arm: copy_loop(): use scratch register
This patch uses r1 as scratch register for copy_loop(). Therefore we do
not longer need r7 for the storage of relocate_code()'s 'addr_moni' (the
destination address of relocation).
Therefore r7 can be used later on for other purposes.
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>
diff --git a/arch/arm/cpu/armv7/start.S b/arch/arm/cpu/armv7/start.S
index de9d1e2..fe98235 100644
--- a/arch/arm/cpu/armv7/start.S
+++ b/arch/arm/cpu/armv7/start.S
@@ -160,7 +160,6 @@
mov r4, r0 /* save addr_sp */
mov r5, r1 /* save addr of gd */
mov r6, r2 /* save addr of destination */
- mov r7, r2 /* save addr of destination */
/* Set up the stack */
stack_setup:
@@ -170,6 +169,7 @@
ldr r2, _TEXT_BASE
ldr r3, _bss_start_ofs
add r2, r0, r3 /* r2 <- source end address */
+ mov r1, r6 /* r1 <- scratch for copy_loop */
cmp r0, r6
#ifndef CONFIG_PRELOADER
beq jump_2_ram
@@ -177,7 +177,7 @@
copy_loop:
ldmia r0!, {r9-r10} /* copy from source address [r0] */
- stmia r6!, {r9-r10} /* copy to target address [r1] */
+ stmia r1!, {r9-r10} /* copy to target address [r1] */
cmp r0, r2 /* until source end address [r2] */
blo copy_loop
@@ -186,7 +186,7 @@
* fix .rel.dyn relocations
*/
ldr r0, _TEXT_BASE /* r0 <- Text base */
- sub r9, r7, r0 /* r9 <- relocation offset */
+ sub r9, r6, r0 /* r9 <- relocation offset */
ldr r10, _dynsym_start_ofs /* r10 <- sym table ofs */
add r10, r10, r0 /* r10 <- sym table in FLASH */
ldr r2, _rel_dyn_start_ofs /* r2 <- rel dyn start ofs */
@@ -225,7 +225,7 @@
ldr r0, _bss_start_ofs
ldr r1, _bss_end_ofs
ldr r3, _TEXT_BASE /* Text base */
- mov r4, r7 /* reloc addr */
+ mov r4, r6 /* reloc addr */
add r0, r0, r4
add r1, r1, r4
mov r2, #0x00000000 /* clear */
@@ -247,7 +247,7 @@
add lr, lr, r9
/* setup parameters for board_init_r */
mov r0, r5 /* gd_t */
- mov r1, r7 /* dest_addr */
+ mov r1, r6 /* dest_addr */
/* jump to it ... */
mov pc, lr