drivers: net: fsl_enetc: move PCS and PHY config to probe

This reduces the time needed to establish a link as we don't reset the link
each time the interface is used.  Our Link capabilities do not change at
run-time so there is no need to re-apply PHY configuration each time.

Signed-off-by: Alex Marginean <alexandru.marginean@nxp.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
diff --git a/drivers/net/fsl_enetc.c b/drivers/net/fsl_enetc.c
index 64dc244..e86f3dd 100644
--- a/drivers/net/fsl_enetc.c
+++ b/drivers/net/fsl_enetc.c
@@ -190,12 +190,6 @@
 	case PHY_INTERFACE_MODE_SGMII_2500:
 		enetc_init_sgmii(dev);
 		break;
-	case PHY_INTERFACE_MODE_RGMII:
-	case PHY_INTERFACE_MODE_RGMII_ID:
-	case PHY_INTERFACE_MODE_RGMII_RXID:
-	case PHY_INTERFACE_MODE_RGMII_TXID:
-		enetc_init_rgmii(dev);
-		break;
 	case PHY_INTERFACE_MODE_XGMII:
 	case PHY_INTERFACE_MODE_USXGMII:
 	case PHY_INTERFACE_MODE_XFI:
@@ -258,6 +252,9 @@
 
 	dm_pci_clrset_config16(dev, PCI_COMMAND, 0, PCI_COMMAND_MEMORY);
 
+	enetc_start_pcs(dev);
+	enetc_config_phy(dev);
+
 	return 0;
 }
 
@@ -433,8 +430,12 @@
 	enetc_setup_tx_bdr(dev);
 	enetc_setup_rx_bdr(dev);
 
-	enetc_start_pcs(dev);
-	enetc_config_phy(dev);
+	if (priv->if_type == PHY_INTERFACE_MODE_RGMII ||
+	    priv->if_type == PHY_INTERFACE_MODE_RGMII_ID ||
+	    priv->if_type == PHY_INTERFACE_MODE_RGMII_RXID ||
+	    priv->if_type == PHY_INTERFACE_MODE_RGMII_TXID)
+		enetc_init_rgmii(dev);
+
 	if (priv->phy)
 		phy_startup(priv->phy);