board/BuR/brppt1: drop DM_I2C_COMPAT
The TPS62517 PMIC driver has been partially converted to DM, so the
legacy I2C access layer isn't needed anymore.
Signed-off-by: Hannes Schmelzer <hannes.schmelzer@br-automation.com>
diff --git a/board/BuR/brppt1/board.c b/board/BuR/brppt1/board.c
index d2e7c72..b8ab19c 100644
--- a/board/BuR/brppt1/board.c
+++ b/board/BuR/brppt1/board.c
@@ -106,9 +106,8 @@
/* setup I2C */
enable_i2c_pin_mux();
- i2c_set_bus_num(0);
- i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
- pmicsetup(0);
+
+ pmicsetup(0, 0);
/* peripheral reset */
rc = gpio_request(64 + 29, "GPMC_WAIT1");
diff --git a/board/BuR/brxre1/board.c b/board/BuR/brxre1/board.c
index 41ed28b..82c53d5 100644
--- a/board/BuR/brxre1/board.c
+++ b/board/BuR/brxre1/board.c
@@ -132,7 +132,7 @@
puts("ERROR: i2c_set_bus_speed failed! (turn on PWR_nEN)\n");
}
- pmicsetup(0);
+ pmicsetup(0, 0);
}
const struct dpll_params *get_dpll_ddr_params(void)
diff --git a/board/BuR/common/bur_common.h b/board/BuR/common/bur_common.h
index 5f2d0d0..f743194 100644
--- a/board/BuR/common/bur_common.h
+++ b/board/BuR/common/bur_common.h
@@ -15,7 +15,7 @@
int load_lcdtiming(struct am335x_lcdpanel *panel);
void br_summaryscreen(void);
-void pmicsetup(u32 mpupll);
+void pmicsetup(u32 mpupll, unsigned int bus);
void enable_uart0_pin_mux(void);
void enable_i2c_pin_mux(void);
void enable_board_pin_mux(void);
diff --git a/board/BuR/common/common.c b/board/BuR/common/common.c
index f3eae5c..a1f7c44 100644
--- a/board/BuR/common/common.c
+++ b/board/BuR/common/common.c
@@ -269,13 +269,14 @@
static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
-void pmicsetup(u32 mpupll)
+void pmicsetup(u32 mpupll, unsigned int bus)
{
int mpu_vdd;
int usb_cur_lim;
- if (i2c_probe(TPS65217_CHIP_PM)) {
- puts("PMIC (0x24) not found! skip further initalization.\n");
+ if (power_tps65217_init(bus)) {
+ printf("WARN: cannot setup PMIC 0x24 @ bus #%d, not found!.\n",
+ bus);
return;
}