ARM: tegra: Initialize timer earlier
A subsequent patch will enable the use of the architected timer on
ARMv8. Doing so implies that udelay() will be backed by this timer
implementation, and hence the architected timer must be ready when
udelay() is first called. The first time udelay() is used is while
resetting the debug UART, which happens very early. Make sure that
arch_timer_init() is called before that.
Signed-off-by: Thierry Reding <treding@nvidia.com>
Acked-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
diff --git a/arch/arm/mach-tegra/board2.c b/arch/arm/mach-tegra/board2.c
index e0d8687..36bcfb0 100644
--- a/arch/arm/mach-tegra/board2.c
+++ b/arch/arm/mach-tegra/board2.c
@@ -196,6 +196,12 @@
int board_early_init_f(void)
{
+ /* Do any special system timer/TSC setup */
+#if defined(CONFIG_TEGRA_SUPPORT_NON_SECURE)
+ if (!tegra_cpu_is_non_secure())
+#endif
+ arch_timer_init();
+
pinmux_init();
board_init_uart_f();
diff --git a/arch/arm/mach-tegra/clock.c b/arch/arm/mach-tegra/clock.c
index 24047b8..5c963d3 100644
--- a/arch/arm/mach-tegra/clock.c
+++ b/arch/arm/mach-tegra/clock.c
@@ -608,12 +608,6 @@
debug("PLLC = %d\n", pll_rate[CLOCK_ID_CGENERAL]);
debug("PLLD = %d\n", pll_rate[CLOCK_ID_DISPLAY]);
debug("PLLX = %d\n", pll_rate[CLOCK_ID_XCPU]);
-
- /* Do any special system timer/TSC setup */
-#if defined(CONFIG_TEGRA_SUPPORT_NON_SECURE)
- if (!tegra_cpu_is_non_secure())
-#endif
- arch_timer_init();
}
static void set_avp_clock_source(u32 src)