blackfin: Correct early serial mess output in BYPASS boot mode.
The early serial should not be configured again in initcode() for BYPASS
boot mode and in start() for the other LDR boot modes.
In BYPASS boot mode, the start up code is located in Nor flash address other
than the DRAM address defined in link script. The code embedded string can't
be addressed by its compile time symbol. Calculate it according to the flash
offset.
Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
diff --git a/arch/blackfin/cpu/serial.h b/arch/blackfin/cpu/serial.h
index 9200339..d67fd81 100644
--- a/arch/blackfin/cpu/serial.h
+++ b/arch/blackfin/cpu/serial.h
@@ -78,19 +78,31 @@
#else
.macro serial_early_init
-#ifdef CONFIG_DEBUG_EARLY_SERIAL
+#if defined(CONFIG_DEBUG_EARLY_SERIAL) && defined(BFIN_BOOT_BYPASS)
call _serial_initialize;
#endif
.endm
.macro serial_early_set_baud
-#ifdef CONFIG_DEBUG_EARLY_SERIAL
+#if defined(CONFIG_DEBUG_EARLY_SERIAL) && defined(BFIN_BOOT_BYPASS)
R0.L = LO(CONFIG_BAUDRATE);
R0.H = HI(CONFIG_BAUDRATE);
call _serial_set_baud;
#endif
.endm
+#if CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_BYPASS
+#define update_serial_early_string_addr \
+ R1.L = _start; \
+ R1.H = _start; \
+ R0 = R0 - R1; \
+ R1.L = 0; \
+ R1.H = 0x2000; \
+ R0 = R0 + R1;
+#else
+#define update_serial_early_string_addr
+#endif
+
/* Since we embed the string right into our .text section, we need
* to find its address. We do this by getting our PC and adding 2
* bytes (which is the length of the jump instruction). Then we
@@ -108,6 +120,7 @@
.previous; \
R0.L = 7b; \
R0.H = 7b; \
+ update_serial_early_string_addr \
call _serial_puts;
#else
# define serial_early_puts(str)