Convert CONFIG_ENV_SPI_* to Kconfig
This converts the following to Kconfig:
CONFIG_ENV_SPI_BUS
CONFIG_ENV_SPI_CS
CONFIG_ENV_SPI_MAX_HZ
CONFIG_ENV_SPI_MODE
Most of time these value are not needed, CONFIG_SF_DEFAULT
with same value is used, so I introduced CONFIG_USE_ENV_SPI_*
to force the associated value for the environment.
Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
diff --git a/env/Kconfig b/env/Kconfig
index c22cbbd..7830066 100644
--- a/env/Kconfig
+++ b/env/Kconfig
@@ -324,18 +324,57 @@
during a "saveenv" operation. CONFIG_ENV_OFFSET_REDUND must be
aligned to an erase sector boundary.
- - CONFIG_ENV_SPI_BUS (optional):
- - CONFIG_ENV_SPI_CS (optional):
+config USE_ENV_SPI_BUS
+ bool "SPI flash bus for environment"
+ depends on ENV_IS_IN_SPI_FLASH
+ help
+ Force the SPI bus for environment.
+ If not defined, use CONFIG_SF_DEFAULT_BUS.
- Define the SPI bus and chip select. If not defined they will be 0.
+config ENV_SPI_BUS
+ int "Value of SPI flash bus for environment"
+ depends on USE_ENV_SPI_BUS
+ help
+ Value the SPI bus and chip select for environment.
- - CONFIG_ENV_SPI_MAX_HZ (optional):
+config USE_ENV_SPI_CS
+ bool "SPI flash chip select for environment"
+ depends on ENV_IS_IN_SPI_FLASH
+ help
+ Force the SPI chip select for environment.
+ If not defined, use CONFIG_SF_DEFAULT_CS.
- Define the SPI max work clock. If not defined then use 1MHz.
+config ENV_SPI_CS
+ int "Value of SPI flash chip select for environment"
+ depends on USE_ENV_SPI_CS
+ help
+ Value of the SPI chip select for environment.
- - CONFIG_ENV_SPI_MODE (optional):
+config USE_ENV_SPI_MAX_HZ
+ bool "SPI flash bus for environment"
+ depends on ENV_IS_IN_SPI_FLASH
+ help
+ Force the SPI max work clock for environment.
+ If not defined, use CONFIG_SF_DEFAULT_SPEED.
- Define the SPI work mode. If not defined then use SPI_MODE_3.
+config ENV_SPI_MAX_HZ
+ int "Value of SPI flash max work for environment"
+ depends on USE_ENV_SPI_MAX_HZ
+ help
+ Value of the SPI max work clock for environment.
+
+config USE_ENV_SPI_MODE
+ bool "SPI flash mode for environment"
+ depends on ENV_IS_IN_SPI_FLASH
+ help
+ Force the SPI work mode for environment.
+
+config ENV_SPI_MODE
+ hex "Value of SPI flash work mode for environment"
+ depends on USE_ENV_SPI_MODE
+ help
+ Value of the SPI work mode for environment.
+ See include/spi.h for value.
config ENV_IS_IN_UBI
bool "Environment in a UBI volume"