dm: pci: Use the correct hose when configuring devices
Only the PCI controller has access to the PCI region information. Make sure
to use the controller (rather than any attached bridges) when configuring
devices.
This corrects a failure to scan and configure devices when driver model is
enabled for PCI.
Also add a comment to explain the problem.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/drivers/pci/pci-uclass.c b/drivers/pci/pci-uclass.c
index de87505..41d19cb 100644
--- a/drivers/pci/pci-uclass.c
+++ b/drivers/pci/pci-uclass.c
@@ -296,6 +296,7 @@
!ret && dev;
ret = device_find_next_child(&dev)) {
struct pci_child_platdata *pplat;
+ struct pci_controller *ctlr_hose;
pplat = dev_get_parent_platdata(dev);
unsigned int max_bus;
@@ -303,7 +304,10 @@
bdf = PCI_ADD_BUS(bus->seq, pplat->devfn);
debug("%s: device %s\n", __func__, dev->name);
- max_bus = pciauto_config_device(hose, bdf);
+
+ /* The root controller has the region information */
+ ctlr_hose = hose->ctlr->uclass_priv;
+ max_bus = pciauto_config_device(ctlr_hose, bdf);
sub_bus = max(sub_bus, max_bus);
}
debug("%s: done\n", __func__);
diff --git a/drivers/pci/pci_common.c b/drivers/pci/pci_common.c
index b9ff23f..f67c9c7 100644
--- a/drivers/pci/pci_common.c
+++ b/drivers/pci/pci_common.c
@@ -11,6 +11,7 @@
*/
#include <common.h>
+#include <dm.h>
#include <errno.h>
#include <pci.h>
#include <asm/io.h>
@@ -221,6 +222,11 @@
return phys_addr;
}
+#ifdef CONFIG_DM_PCI
+ /* The root controller has the region information */
+ hose = hose->ctlr->uclass_priv;
+#endif
+
/*
* if PCI_REGION_MEM is set we do a two pass search with preference
* on matches that don't have PCI_REGION_SYS_MEMORY set