spl: Make SPL_DISABLE_BANNER_PRINT a positive option
Rather than having a negative option, make this a positive option and
enable it by default. This makes it easier to understand.
Reviewed-by: Tom Rini <trini@konsulko.com>
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 365e692..32fa575 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -135,12 +135,21 @@
location is used. Normally we put the device tree at the end of BSS
but with this option enabled, it goes at _image_binary_end.
-config SPL_DISABLE_BANNER_PRINT
- bool "Disable output of the SPL banner 'U-Boot SPL ...'"
+config SPL_BANNER_PRINT
+ bool "Enable output of the SPL banner 'U-Boot SPL ...'"
+ default y
+ help
+ If this option is enabled, SPL will print the banner with version
+ info. Disabling this option could be useful to reduce TPL boot time
+ (e.g. approx. 6 ms faster, when output on i.MX6 with 115200 baud).
+
+config TPL_BANNER_PRINT
+ bool "Enable output of the TPL banner 'U-Boot TPL ...'"
+ default y
help
If this option is enabled, SPL will not print the banner with version
- info. Selecting this option could be useful to reduce SPL boot time
- (e.g. approx. 6 ms slower, when output on i.MX6 with 115200 baud).
+ info. Disabling this option could be useful to reduce SPL boot time
+ (e.g. approx. 6 ms faster, when output on i.MX6 with 115200 baud).
config SPL_DISPLAY_PRINT
bool "Display a board-specific message in SPL"