xpedite1k: Add support for additional GPIO pins
Enable GPIO pins for an I2C EEPROM write protect, a system reset pin,
and a PMC #MONARCH pin. These pins are not currently used in U-Boot,
but are used in OSes and may be used in U-Boot in the future.
Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/xpedite1k/xpedite1k.c b/board/xpedite1k/xpedite1k.c
index 8a3503d..ed864ba 100644
--- a/board/xpedite1k/xpedite1k.c
+++ b/board/xpedite1k/xpedite1k.c
@@ -32,9 +32,18 @@
{
unsigned long sdrreg;
- /* TBS: Setup the GPIO access for the user LEDs */
+ /*
+ * Enable GPIO for pins 18 - 24
+ * 18 = SEEPROM_WP
+ * 19 = #M_RST
+ * 20 = #MONARCH
+ * 21 = #LED_ALARM
+ * 22 = #LED_ACT
+ * 23 = #LED_STATUS1
+ * 24 = #LED_STATUS2
+ */
mfsdr(sdr_pfc0, sdrreg);
- mtsdr(sdr_pfc0, (sdrreg & ~0x00000100) | 0x00000E00);
+ mtsdr(sdr_pfc0, (sdrreg & ~SDR0_PFC0_TRE_ENABLE) | 0x00003e00);
out32(CONFIG_SYS_GPIO_BASE + 0x018, (USR_LED0 | USR_LED1 | USR_LED2 | USR_LED3));
LED0_OFF();
LED1_OFF();