ppc4xx: Remove superfluous dram_init() call or replace it by initdram()
Historically the 405 U-Boot port had a dram_init() call in early init
stage. This function was still called from start.S and most of the time
coded in assembler. This is not needed anymore (since a long time) and
boards should implement the common initdram() function in C instead.
This patch now removed the dram_init() call from start.S and removes the
empty implementations that are scattered through most of the 405 board
ports. Some older board ports really implement this dram_init() though.
These are:
csb272
csb472
ERIC
EXBITGEN
W7OLMC
W7OLMG
I changed those boards to call this assembler dram_init() function now
from their board specific initdram() instead. This *should* work, but please
test again on those platforms. And it is perhaps a good idea that those
boards use some common 405 SDRAM initialization code from cpu/ppc4xx at
some time. So further patches welcome here.
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/board/eric/eric.c b/board/eric/eric.c
index 5413ae1..14ba9b0 100644
--- a/board/eric/eric.c
+++ b/board/eric/eric.c
@@ -31,6 +31,8 @@
#define PPC405GP_GPIO0_ODR 0xef600718 /* GPIO Open Drain */
#define PPC405GP_GPIO0_IR 0xef60071c /* GPIO Input */
+void sdram_init(void);
+
int board_early_init_f (void)
{
@@ -127,6 +129,12 @@
int TotalSize;
#endif
+ /*
+ * ToDo: Move the asm init routine sdram_init() to this C file,
+ * or even better use some common ppc4xx code available
+ * in cpu/ppc4xx
+ */
+ sdram_init();
#ifdef CONFIG_ERIC
/*