spi: altera: Clean up the use of variable d
The variable d is used in rather questionable way. Rework the code
a bit so it's clearer what it does. Also, rename the variable from
d to data to make it's name less mysterious. Finally, change it's
data type to uint32_t , since it's accessed as a 32bit number.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: Chin Liang See <clsee@altera.com>
Cc: Dinh Nguyen <dinguyen@altera.com>
Cc: Albert Aribaud <albert.u.boot@aribaud.net>
Cc: Pavel Machek <pavel@denx.de>
Cc: Jagannadha Sutradharudu Teki <jagannadh.teki@gmail.com>
Acked-by: Pavel Machek <pavel@denx.de>
Reviewed-by: Jagannadha Sutradharudu Teki <jagannadh.teki@gmail.com>
diff --git a/drivers/spi/altera_spi.c b/drivers/spi/altera_spi.c
index 8e898b9..c08969d 100644
--- a/drivers/spi/altera_spi.c
+++ b/drivers/spi/altera_spi.c
@@ -126,10 +126,10 @@
{
struct altera_spi_slave *altspi = to_altera_spi_slave(slave);
/* assume spi core configured to do 8 bit transfers */
- uint bytes = bitlen / 8;
- const uchar *txp = dout;
- uchar *rxp = din;
- uint32_t reg, start;
+ unsigned int bytes = bitlen / 8;
+ const unsigned char *txp = dout;
+ unsigned char *rxp = din;
+ uint32_t reg, data, start;
debug("%s: bus:%i cs:%i bitlen:%i bytes:%i flags:%lx\n", __func__,
slave->bus, slave->cs, bitlen, bytes, flags);
@@ -150,10 +150,13 @@
spi_cs_activate(slave);
while (bytes--) {
- uchar d = txp ? *txp++ : CONFIG_ALTERA_SPI_IDLE_VAL;
+ if (txp)
+ data = *txp++;
+ else
+ data = CONFIG_ALTERA_SPI_IDLE_VAL;
- debug("%s: tx:%x ", __func__, d);
- writel(d, &altspi->regs->txdata);
+ debug("%s: tx:%x ", __func__, data);
+ writel(data, &altspi->regs->txdata);
start = get_timer(0);
while (1) {
@@ -166,11 +169,11 @@
}
}
- d = readl(&altspi->regs->rxdata);
+ data = readl(&altspi->regs->rxdata);
if (rxp)
- *rxp++ = d;
+ *rxp++ = data & 0xff;
- debug("rx:%x\n", d);
+ debug("rx:%x\n", data);
}
done: