Migrate esd 405EP boards to new NAND subsystem
Migrate esd 405EP boards to new NAND subsystem
-cleanup
-use correct io accessors (in/out_be32())
Signed-off-by: Matthias Fuchs <matthias.fuchs@esd-electronics.com>
diff --git a/board/esd/voh405/Makefile b/board/esd/voh405/Makefile
index 4d75868..308f752 100644
--- a/board/esd/voh405/Makefile
+++ b/board/esd/voh405/Makefile
@@ -28,7 +28,9 @@
LIB = $(obj)lib$(BOARD).a
-COBJS = $(BOARD).o flash.o ../common/misc.o
+COBJS = $(BOARD).o flash.o \
+ ../common/misc.o \
+ ../common/esd405ep_nand.o \
SRCS := $(SOBJS:.o=.S) $(COBJS:.o=.c)
OBJS := $(addprefix $(obj),$(COBJS))
diff --git a/board/esd/voh405/voh405.c b/board/esd/voh405/voh405.c
index 22995b5..2857a0b 100644
--- a/board/esd/voh405/voh405.c
+++ b/board/esd/voh405/voh405.c
@@ -195,12 +195,6 @@
udelay(1000); /* wait 1ms */
/*
- * Set NAND-FLASH GPIO signals to default
- */
- out32(GPIO0_OR, in32(GPIO0_OR) & ~(CFG_NAND_CLE | CFG_NAND_ALE));
- out32(GPIO0_OR, in32(GPIO0_OR) | CFG_NAND_CE);
-
- /*
* Enable interrupts in exar duart mcr[3]
*/
*duart0_mcr = 0x08;
@@ -340,17 +334,3 @@
}
}
#endif /* CONFIG_IDE_RESET */
-
-
-#if (CONFIG_COMMANDS & CFG_CMD_NAND)
-#include <linux/mtd/nand_legacy.h>
-extern struct nand_chip nand_dev_desc[CFG_MAX_NAND_DEVICE];
-
-void nand_init(void)
-{
- nand_probe(CFG_NAND_BASE);
- if (nand_dev_desc[0].ChipID != NAND_ChipID_UNKNOWN) {
- print_size(nand_dev_desc[0].totlen, "\n");
- }
-}
-#endif