mx6qsabrelite: No need to set the direction for GPIO3_23 again
There is a 'gpio_direction_output(87, 0);' call previously, so the GPIO direction is
already established.
Use gpio_set_value() for changing the GPIO output then.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Acked-by: Dirk Behme <dirk.behme@googlemail.com>
diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
index fda3e41..b4d9519 100644
--- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
+++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
@@ -135,7 +135,7 @@
/* Need delay 10ms according to KSZ9021 spec */
udelay(1000 * 10);
- gpio_direction_output(87, 1); /* GPIO 3-23 */
+ gpio_set_value(87, 1); /* GPIO 3-23 */
imx_iomux_v3_setup_multiple_pads(enet_pads2, ARRAY_SIZE(enet_pads2));
}