ARM: uniphier: do not use RAM that exceeds 32 bit address range
LD20 / PXs3 boards are equipped with a large amount of memory beyond
the 32 bit address range. U-Boot relocates itself to the end of the
available RAM.
This is a problem for DMA engines that only support 32 bit physical
address, like the SDMA of SDHCI controllers.
In fact, U-Boot does not need to run at the very end of RAM. It is
rather troublesome for drivers with DMA engines because U-Boot does
not have API like dma_set_mask(), so DMA silently fails, making the
driver debugging difficult.
Hide the memory region that exceeds the 32 bit address range. It can
be done by simply carving out gd->ram_size. It would also possible to
override get_effective_memsize() or to define CONFIG_MAX_MEM_MAPPED,
but dram_init() is a good enough place to do this job.
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
diff --git a/arch/arm/mach-uniphier/dram_init.c b/arch/arm/mach-uniphier/dram_init.c
index e9672d2..cb35dab 100644
--- a/arch/arm/mach-uniphier/dram_init.c
+++ b/arch/arm/mach-uniphier/dram_init.c
@@ -205,6 +205,7 @@
return ret;
for (i = 0; i < ARRAY_SIZE(dram_map); i++) {
+ unsigned long max_size;
if (!dram_map[i].size)
break;
@@ -218,6 +219,22 @@
dram_map[i].base)
break;
+ /*
+ * Do not use memory that exceeds 32bit address range. U-Boot
+ * relocates itself to the end of the effectively available RAM.
+ * This could be a problem for DMA engines that do not support
+ * 64bit address (SDMA of SDHCI, UniPhier AV-ether, etc.)
+ */
+ if (dram_map[i].base >= 1ULL << 32)
+ break;
+
+ max_size = (1ULL << 32) - dram_map[i].base;
+
+ if (dram_map[i].size > max_size) {
+ gd->ram_size += max_size;
+ break;
+ }
+
gd->ram_size += dram_map[i].size;
}