Merge branch 'master' of git://git.denx.de/u-boot-sunxi
diff --git a/arch/arm/mach-sunxi/Kconfig b/arch/arm/mach-sunxi/Kconfig
index 560dc9b..3c54f51 100644
--- a/arch/arm/mach-sunxi/Kconfig
+++ b/arch/arm/mach-sunxi/Kconfig
@@ -230,6 +230,7 @@
select PHY_SUN4I_USB
select SUNXI_GEN_SUN6I
select MMC_SUNXI_HAS_NEW_MODE
+ select MMC_SUNXI_HAS_MODE_SWITCH
select SUPPORT_SPL
config MACH_SUN8I_H3
@@ -281,6 +282,7 @@
select SUN6I_PRCM
select SUNXI_DE2
select SUNXI_GEN_SUN6I
+ select MMC_SUNXI_HAS_NEW_MODE
select SUPPORT_SPL
select SUNXI_DRAM_DW
select SUNXI_DRAM_DW_32BIT
diff --git a/arch/arm/mach-sunxi/dram_sun8i_a33.c b/arch/arm/mach-sunxi/dram_sun8i_a33.c
index d9aa0c6..1da2727 100644
--- a/arch/arm/mach-sunxi/dram_sun8i_a33.c
+++ b/arch/arm/mach-sunxi/dram_sun8i_a33.c
@@ -334,7 +334,7 @@
struct dram_para para = {
.cs1 = 0,
.bank = 1,
- .rank = 1,
+ .rank = 2,
.rows = 15,
.bus_width = 16,
.page_size = 2048,
diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig
index 27246ee..3f7458d 100644
--- a/drivers/mmc/Kconfig
+++ b/drivers/mmc/Kconfig
@@ -569,6 +569,10 @@
bool
depends on MMC_SUNXI
+config MMC_SUNXI_HAS_MODE_SWITCH
+ bool
+ depends on MMC_SUNXI
+
config GENERIC_ATMEL_MCI
bool "Atmel Multimedia Card Interface support"
depends on DM_MMC && BLK && ARCH_AT91
diff --git a/drivers/mmc/sunxi_mmc.c b/drivers/mmc/sunxi_mmc.c
index 147eb9b..9bf040c 100644
--- a/drivers/mmc/sunxi_mmc.c
+++ b/drivers/mmc/sunxi_mmc.c
@@ -98,24 +98,21 @@
static int mmc_set_mod_clk(struct sunxi_mmc_priv *priv, unsigned int hz)
{
unsigned int pll, pll_hz, div, n, oclk_dly, sclk_dly;
- bool new_mode = false;
+ bool new_mode = true;
bool calibrate = false;
u32 val = 0;
- if (IS_ENABLED(CONFIG_MMC_SUNXI_HAS_NEW_MODE) && (priv->mmc_no == 2))
- new_mode = true;
+ if (!IS_ENABLED(CONFIG_MMC_SUNXI_HAS_NEW_MODE))
+ new_mode = false;
+
+ /* A83T support new mode only on eMMC */
+ if (IS_ENABLED(CONFIG_MACH_SUN8I_A83T) && priv->mmc_no != 2)
+ new_mode = false;
#if defined(CONFIG_MACH_SUN50I) || defined(CONFIG_MACH_SUN50I_H6)
calibrate = true;
#endif
- /*
- * The MMC clock has an extra /2 post-divider when operating in the new
- * mode.
- */
- if (new_mode)
- hz = hz * 2;
-
if (hz <= 24000000) {
pll = CCM_MMC_CTRL_OSCM24;
pll_hz = 24000000;
@@ -176,7 +173,9 @@
if (new_mode) {
#ifdef CONFIG_MMC_SUNXI_HAS_NEW_MODE
+#ifdef CONFIG_MMC_SUNXI_HAS_MODE_SWITCH
val = CCM_MMC_CTRL_MODE_SEL_NEW;
+#endif
setbits_le32(&priv->reg->ntsr, SUNXI_MMC_NTSR_MODE_SEL_NEW);
#endif
} else if (!calibrate) {
diff --git a/drivers/net/sun8i_emac.c b/drivers/net/sun8i_emac.c
index 3ba3a1f..c979844 100644
--- a/drivers/net/sun8i_emac.c
+++ b/drivers/net/sun8i_emac.c
@@ -60,6 +60,10 @@
#define SC_ETCS_MASK GENMASK(1, 0)
#define SC_ETCS_EXT_GMII 0x1
#define SC_ETCS_INT_GMII 0x2
+#define SC_ETXDC_MASK GENMASK(12, 10)
+#define SC_ETXDC_OFFSET 10
+#define SC_ERXDC_MASK GENMASK(9, 5)
+#define SC_ERXDC_OFFSET 5
#define CONFIG_MDIO_TIMEOUT (3 * CONFIG_SYS_HZ)
@@ -140,6 +144,8 @@
struct sun8i_eth_pdata {
struct eth_pdata eth_pdata;
u32 reset_delays[3];
+ int tx_delay_ps;
+ int rx_delay_ps;
};
@@ -273,7 +279,8 @@
return 0;
}
-static int sun8i_emac_set_syscon(struct emac_eth_dev *priv)
+static int sun8i_emac_set_syscon(struct sun8i_eth_pdata *pdata,
+ struct emac_eth_dev *priv)
{
int ret;
u32 reg;
@@ -312,6 +319,14 @@
return -EINVAL;
}
+ if (pdata->tx_delay_ps)
+ reg |= ((pdata->tx_delay_ps / 100) << SC_ETXDC_OFFSET)
+ & SC_ETXDC_MASK;
+
+ if (pdata->rx_delay_ps)
+ reg |= ((pdata->rx_delay_ps / 100) << SC_ERXDC_OFFSET)
+ & SC_ERXDC_MASK;
+
writel(reg, priv->sysctl_reg + 0x30);
return 0;
@@ -784,13 +799,14 @@
static int sun8i_emac_eth_probe(struct udevice *dev)
{
- struct eth_pdata *pdata = dev_get_platdata(dev);
+ struct sun8i_eth_pdata *sun8i_pdata = dev_get_platdata(dev);
+ struct eth_pdata *pdata = &sun8i_pdata->eth_pdata;
struct emac_eth_dev *priv = dev_get_priv(dev);
priv->mac_reg = (void *)pdata->iobase;
sun8i_emac_board_setup(priv);
- sun8i_emac_set_syscon(priv);
+ sun8i_emac_set_syscon(sun8i_pdata, priv);
sun8i_mdio_init(dev->name, dev);
priv->bus = miiphy_get_dev_by_name(dev->name);
@@ -891,6 +907,18 @@
if (!priv->use_internal_phy)
parse_phy_pins(dev);
+ sun8i_pdata->tx_delay_ps = fdtdec_get_int(gd->fdt_blob, node,
+ "allwinner,tx-delay-ps", 0);
+ if (sun8i_pdata->tx_delay_ps < 0 || sun8i_pdata->tx_delay_ps > 700)
+ printf("%s: Invalid TX delay value %d\n", __func__,
+ sun8i_pdata->tx_delay_ps);
+
+ sun8i_pdata->rx_delay_ps = fdtdec_get_int(gd->fdt_blob, node,
+ "allwinner,rx-delay-ps", 0);
+ if (sun8i_pdata->rx_delay_ps < 0 || sun8i_pdata->rx_delay_ps > 3100)
+ printf("%s: Invalid RX delay value %d\n", __func__,
+ sun8i_pdata->rx_delay_ps);
+
#ifdef CONFIG_DM_GPIO
if (fdtdec_get_bool(gd->fdt_blob, dev_of_offset(dev),
"snps,reset-active-low"))