powerpc/8xxx: Refactor fsl_ddr_get_spd into common code from board
Move fsl_ddr_get_spd into common mpc8xxx/ddr/main.c as most boards
pretty much do the same thing. The only variations are in how many
controllers or DIMMs per controller exist. To make this work we
standardize on the names of the SPD_EEPROM_ADDRESS defines based on the
use case of the board.
We allow boards to override get_spd to either do board specific fixups
to the SPD data or deal with any unique behavior of how the SPD eeproms
are wired up.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/board/xes/xpedite550x/ddr.c b/board/xes/xpedite550x/ddr.c
index 9e69649..3b6e08b 100644
--- a/board/xes/xpedite550x/ddr.c
+++ b/board/xes/xpedite550x/ddr.c
@@ -27,25 +27,12 @@
#include <asm/fsl_ddr_sdram.h>
#include <asm/fsl_ddr_dimm_params.h>
-static void get_spd(ddr3_spd_eeprom_t *spd, unsigned char i2c_address)
+void get_spd(ddr3_spd_eeprom_t *spd, u8 i2c_address)
{
i2c_read(i2c_address, SPD_EEPROM_OFFSET, 2, (uchar *)spd,
sizeof(ddr3_spd_eeprom_t));
}
-void fsl_ddr_get_spd(ddr3_spd_eeprom_t *ctrl_dimms_spd,
- unsigned int ctrl_num)
-{
- unsigned int i;
- unsigned int i2c_address = 0;
-
- for (i = 0; i < CONFIG_DIMM_SLOTS_PER_CTLR; i++) {
- if (ctrl_num == 0 && i == 0)
- i2c_address = SPD_EEPROM_ADDRESS1;
- get_spd(&(ctrl_dimms_spd[i]), i2c_address);
- }
-}
-
/*
* There are traditionally three board-specific SDRAM timing parameters
* which must be calculated based on the particular PCB artwork. These are: