SECURE BOOT: Halt execution when secure boot fail
In case of fatal failure during secure boot execution (e.g. header
not found), reset is asserted to stop execution. If the RESET_REQ
is not tied to HRESET, this allows the execution to continue.
Add esbh_halt() after the reset to make sure execution stops.
Signed-off-by: Aneesh Bansal <aneesh.bansal@nxp.com>
Signed-off-by: Saksham Jain <saksham.jain@nxp.com>
Reviewed-by: York Sun <york.sun@nxp.com>
diff --git a/board/freescale/common/fsl_validate.c b/board/freescale/common/fsl_validate.c
index c12b9c9..95059c7 100644
--- a/board/freescale/common/fsl_validate.c
+++ b/board/freescale/common/fsl_validate.c
@@ -325,6 +325,8 @@
printf("Generating reset request\n");
do_reset(NULL, 0, 0, NULL);
+ /* If reset doesn't coocur, halt execution */
+ do_esbc_halt(NULL, 0, 0, NULL);
}
/*
@@ -355,6 +357,9 @@
printf("Generating reset request\n");
do_reset(NULL, 0, 0, NULL);
+ /* If reset doesn't coocur, halt execution */
+ do_esbc_halt(NULL, 0, 0, NULL);
+
} else {
change_sec_mon_state(HPSR_SSM_ST_TRUST,
HPSR_SSM_ST_NON_SECURE);