B4860qds: Set SerDes2 refclk2 at to 156.25MHz for XFI to work
Change setting of SerDes2 refclk2 to have the default value as it is
coming on board that is 156.25MHz, for XFI to work.
Also change PLL_NUM variable to the one defined in config_mpc85xx.h
for B4860 and B4420.
Signed-off-by: Shaveta Leekha <shaveta@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/board/freescale/b4860qds/b4860qds.c b/board/freescale/b4860qds/b4860qds.c
index 25b3be8..24a709e 100644
--- a/board/freescale/b4860qds/b4860qds.c
+++ b/board/freescale/b4860qds/b4860qds.c
@@ -29,7 +29,6 @@
#define CLK_MUX_SEL_MASK 0x4
#define ETH_PHY_CLK_OUT 0x4
-#define PLL_NUM 2
DECLARE_GLOBAL_DATA_PTR;
@@ -386,7 +385,7 @@
/* Steps For SerDes PLLs reset and reconfiguration after
* changing SerDes's refclks
*/
- for (i = 0; i < PLL_NUM; i++) {
+ for (i = 0; i < CONFIG_SYS_FSL_SRDS_NUM_PLLS; i++) {
debug("For PLL%d reset and reconfiguration after"
" changing refclks\n", i+1);
clrbits_be32(&srds_regs->bank[i].rstctl,
@@ -453,7 +452,7 @@
if (!ret) {
ret = set_serdes_refclk(IDT_SERDES2_ADDRESS, 2,
SERDES_REFCLK_100,
- SERDES_REFCLK_100, 0);
+ SERDES_REFCLK_156_25, 0);
if (ret) {
printf("IDT8T49N222A configuration failed.\n");
goto out;
@@ -467,7 +466,7 @@
/* Steps For SerDes PLLs reset and reconfiguration after
* changing SerDes's refclks
*/
- for (i = 0; i < PLL_NUM; i++) {
+ for (i = 0; i < CONFIG_SYS_FSL_SRDS_NUM_PLLS; i++) {
clrbits_be32(&srds2_regs->bank[i].rstctl,
SRDS_RSTCTL_SDRST_B);
udelay(10);