AFEB9260 network fix
AFEB9260 uses PA10, PA11 for ETX2 and ETX3.
Also, due to extarnal pull-up on IRQ line, Micrel PHY ID is 1 after reset sequence,
not 0.
Signed-off-by: Sergey Lapin <slapin@ossfans.org>
diff --git a/board/afeb9260/afeb9260.c b/board/afeb9260/afeb9260.c
index 024db2b..a247663 100644
--- a/board/afeb9260/afeb9260.c
+++ b/board/afeb9260/afeb9260.c
@@ -177,7 +177,7 @@
{
int rc = 0;
#ifdef CONFIG_MACB
- rc = macb_eth_initialize(0, (void *)AT91SAM9260_BASE_EMAC, 0x00);
+ rc = macb_eth_initialize(0, (void *)AT91SAM9260_BASE_EMAC, 0x01);
#endif
return rc;
}
diff --git a/cpu/arm926ejs/at91/at91sam9260_macb.c b/cpu/arm926ejs/at91/at91sam9260_macb.c
index ab60fb7..ea5e767 100644
--- a/cpu/arm926ejs/at91/at91sam9260_macb.c
+++ b/cpu/arm926ejs/at91/at91sam9260_macb.c
@@ -47,7 +47,7 @@
at91_set_B_periph(AT91_PIN_PA25, 0); /* ERX2 */
at91_set_B_periph(AT91_PIN_PA26, 0); /* ERX3 */
at91_set_B_periph(AT91_PIN_PA27, 0); /* ERXCK */
-#if defined(CONFIG_AT91SAM9260EK)
+#if defined(CONFIG_AT91SAM9260EK) || defined(CONFIG_AFEB9260)
/*
* use PA10, PA11 for ETX2, ETX3.
* PA23 and PA24 are for TWI EEPROM