85xx: Use proper defines for PCI addresses
We should be using the _MEM_PHYS for LAW and TLB setup and not _MEM_BASE.
While _MEM_BASE & _MEM_PHYS are normally the same, _MEM_BASE should only
be used for configuring the PCI ATMU.
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/board/pm856/law.c b/board/pm856/law.c
index 65a4b59..cb6b37f 100644
--- a/board/pm856/law.c
+++ b/board/pm856/law.c
@@ -48,7 +48,7 @@
#ifndef CONFIG_SPD_EEPROM
SET_LAW_ENTRY(1, CFG_DDR_SDRAM_BASE, LAW_SIZE_256M, LAW_TRGT_IF_DDR),
#endif
- SET_LAW_ENTRY(2, CFG_PCI1_MEM_BASE, LAW_SIZE_512M, LAW_TRGT_IF_PCI),
+ SET_LAW_ENTRY(2, CFG_PCI1_MEM_PHYS, LAW_SIZE_512M, LAW_TRGT_IF_PCI),
/* This is not so much the SDRAM map as it is the whole localbus map. */
SET_LAW_ENTRY(3, CFG_LBC_SDRAM_BASE, LAW_SIZE_256M, LAW_TRGT_IF_LBC),
SET_LAW_ENTRY(4, CFG_PCI1_IO_PHYS, LAW_SIZE_16M, LAW_TRGT_IF_PCI),