xilinx: Setup bootm variables
On system with PL DDR which is placed before PS DDR in DT
env_get_bootm_size() and env_get_bootm_low() without specifying bootm_low
and bootm_size variables are taking by default gd->bd->bi_dram[0].start and
gd->bd->bi_dram[0].size. As you see 0 means bank 0 which doesn't need to be
PS ddr and even can be memory above 39bit VA which is what U-Boot supports
now.
That's why setup bootm variables based on ram_base/ram_size setting to make
sure that boot images are placed to the same location as U-Boot is placed.
This location should be by default location where OS can boot from.
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
diff --git a/board/xilinx/common/board.c b/board/xilinx/common/board.c
index 0469e2e..3bca3a2 100644
--- a/board/xilinx/common/board.c
+++ b/board/xilinx/common/board.c
@@ -86,5 +86,8 @@
initrd_hi = round_down(initrd_hi, SZ_16M);
env_set_addr("initrd_high", (void *)initrd_hi);
+ env_set_addr("bootm_low", (void *)gd->ram_base);
+ env_set_addr("bootm_size", (void *)gd->ram_size);
+
return 0;
}