Wait for the link to come up on kirkwood network init
This patch makes the device wait for up to 5 seconds for the link to
come up, similar to what many of the other network drivers do. This
avoids confusing situations where, e.g., a tftp fails when initiated
early after U-boot has started (before the link has come up).
Signed-off-by: Simon Kagstrom <simon.kagstrom@netinsight.net>
Signed-off-by: Ben Warren <biggerbadderben@gmail.com>
diff --git a/drivers/net/kirkwood_egiga.c b/drivers/net/kirkwood_egiga.c
index 065e335..9f36633 100644
--- a/drivers/net/kirkwood_egiga.c
+++ b/drivers/net/kirkwood_egiga.c
@@ -400,6 +400,7 @@
{
struct kwgbe_device *dkwgbe = to_dkwgbe(dev);
struct kwgbe_registers *regs = dkwgbe->regs;
+ int i;
/* setup RX rings */
kwgbe_init_rx_desc_ring(dkwgbe);
@@ -447,13 +448,20 @@
#if (defined (CONFIG_MII) || defined (CONFIG_CMD_MII)) \
&& defined (CONFIG_SYS_FAULT_ECHO_LINK_DOWN)
- u16 phyadr;
- miiphy_read(dev->name, KIRKWOOD_PHY_ADR_REQUEST,
- KIRKWOOD_PHY_ADR_REQUEST, &phyadr);
- if (!miiphy_link(dev->name, phyadr)) {
- printf("%s: No link on %s\n", __FUNCTION__, dev->name);
- return -1;
+ /* Wait up to 5s for the link status */
+ for (i = 0; i < 5; i++) {
+ u16 phyadr;
+
+ miiphy_read(dev->name, KIRKWOOD_PHY_ADR_REQUEST,
+ KIRKWOOD_PHY_ADR_REQUEST, &phyadr);
+ /* Return if we get link up */
+ if (miiphy_link(dev->name, phyadr))
+ return 0;
+ udelay(1000000);
}
+
+ printf("No link on %s\n", dev->name);
+ return -1;
#endif
return 0;
}