armv8: ls1012a: RGMII ports require internal delay
The correct setting for the RGMII ports on LS1012ARDB is to
enable delay on both Rx and Tx so the interface mode used should
be PHY_INTERFACE_MODE_RGMII_ID
Signed-off-by: Chaitanya Sakinam <chaitanya.sakinam@nxp.com>
Signed-off-by: Anji J <anji.jagarlmudi@nxp.com>
Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com>
diff --git a/board/freescale/ls1012ardb/eth.c b/board/freescale/ls1012ardb/eth.c
index 63d40de..a65ff4d 100644
--- a/board/freescale/ls1012ardb/eth.c
+++ b/board/freescale/ls1012ardb/eth.c
@@ -113,7 +113,7 @@
/* MAC2 */
pfe_set_phy_address_mode(priv->gemac_port,
CONFIG_PFE_EMAC2_PHY_ADDR,
- PHY_INTERFACE_MODE_RGMII_TXID);
+ PHY_INTERFACE_MODE_RGMII_ID);
}
break;
case 0x2208:
diff --git a/drivers/net/pfe_eth/pfe_eth.c b/drivers/net/pfe_eth/pfe_eth.c
index 718e24f..e49bf4a 100644
--- a/drivers/net/pfe_eth/pfe_eth.c
+++ b/drivers/net/pfe_eth/pfe_eth.c
@@ -33,7 +33,7 @@
/* phy iface */
.phy_address = CONFIG_PFE_EMAC2_PHY_ADDR,
- .phy_mode = PHY_INTERFACE_MODE_RGMII_TXID,
+ .phy_mode = PHY_INTERFACE_MODE_RGMII_ID,
},
};