mmc: if possible, poll the busy state using DAT0

Using the DAT0 line as a rdy/busy line is an alternative to reading the
status register of the card. It especially useful in situation where the
bus is not in a good shape, like when modes are switched.
This is also how the linux driver behaves.

Note of warning: As per the specification, while polling on DAT0 the CLK
must not turned off: "[...] Without a clock edge the Device (unless
previously disconnected by a deselect command (CMD7)) will force the DAT0
line down, forever. [...]"

Signed-off-by: Jean-Jacques Hiblot <jjhiblot@ti.com>
diff --git a/drivers/mmc/mmc-uclass.c b/drivers/mmc/mmc-uclass.c
index 923a3b1..9327c83 100644
--- a/drivers/mmc/mmc-uclass.c
+++ b/drivers/mmc/mmc-uclass.c
@@ -47,7 +47,6 @@
 	return dm_mmc_set_ios(mmc->dev);
 }
 
-#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)
 int dm_mmc_wait_dat0(struct udevice *dev, int state, int timeout)
 {
 	struct dm_mmc_ops *ops = mmc_get_ops(dev);
@@ -61,7 +60,6 @@
 {
 	return dm_mmc_wait_dat0(mmc->dev, state, timeout);
 }
-#endif
 
 int dm_mmc_get_wp(struct udevice *dev)
 {
diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
index 36cce79..a61e311 100644
--- a/drivers/mmc/mmc.c
+++ b/drivers/mmc/mmc.c
@@ -29,12 +29,10 @@
 
 #if !CONFIG_IS_ENABLED(DM_MMC)
 
-#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)
 static int mmc_wait_dat0(struct mmc *mmc, int state, int timeout)
 {
 	return -ENOSYS;
 }
-#endif
 
 __weak int board_mmc_getwp(struct mmc *mmc)
 {
@@ -233,6 +231,10 @@
 	unsigned int status;
 	int err;
 
+	err = mmc_wait_dat0(mmc, 1, timeout);
+	if (err != -ENOSYS)
+		return err;
+
 	while (1) {
 		err = mmc_send_status(mmc, &status);
 		if (err)
diff --git a/include/mmc.h b/include/mmc.h
index 7f95c35..cf83b74 100644
--- a/include/mmc.h
+++ b/include/mmc.h
@@ -445,7 +445,6 @@
 	int (*execute_tuning)(struct udevice *dev, uint opcode);
 #endif
 
-#if CONFIG_IS_ENABLED(MMC_UHS_SUPPORT)
 	/**
 	 * wait_dat0() - wait until dat0 is in the target state
 	 *		(CLK must be running during the wait)
@@ -456,7 +455,6 @@
 	 * @return 0 if dat0 is in the target state, -ve on error
 	 */
 	int (*wait_dat0)(struct udevice *dev, int state, int timeout);
-#endif
 };
 
 #define mmc_get_ops(dev)        ((struct dm_mmc_ops *)(dev)->driver->ops)