| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Copyright 2019 NXP |
| */ |
| |
| #include "imx8mm-u-boot.dtsi" |
| |
| / { |
| firmware { |
| optee { |
| compatible = "linaro,optee-tz"; |
| method = "smc"; |
| }; |
| }; |
| |
| wdt-reboot { |
| compatible = "wdt-reboot"; |
| bootph-pre-ram; |
| wdt = <&wdog1>; |
| }; |
| }; |
| |
| &{/soc@0/bus@30800000/i2c@30a30000/pmic@4b} { |
| bootph-pre-ram; |
| }; |
| |
| &{/soc@0/bus@30800000/i2c@30a30000/pmic@4b/regulators} { |
| bootph-pre-ram; |
| }; |
| |
| &binman_fip { |
| arch = "arm64"; |
| compression = "none"; |
| description = "Trusted Firmware FIP"; |
| load = <0x40310000>; |
| type = "firmware"; |
| |
| fip_blob { |
| filename = "fip.bin"; |
| type = "blob-ext"; |
| }; |
| }; |
| |
| /* This cannot work since it refers to a template node |
| &binman_configuration { |
| loadables = "atf", "fip"; |
| }; |
| */ |
| |
| &fec1 { |
| phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>; |
| }; |
| |
| &gpio1 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio2 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio3 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio4 { |
| bootph-pre-ram; |
| }; |
| |
| &gpio5 { |
| bootph-pre-ram; |
| }; |
| |
| &i2c1 { |
| bootph-pre-ram; |
| }; |
| |
| &i2c2 { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_i2c2 { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_pmic { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_uart3 { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_usdhc2 { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_usdhc2_gpio { |
| bootph-pre-ram; |
| }; |
| |
| &pinctrl_usdhc3 { |
| bootph-pre-ram; |
| }; |
| |
| &uart3 { |
| bootph-pre-ram; |
| }; |
| |
| &usdhc1 { |
| bootph-pre-ram; |
| }; |
| |
| &usdhc2 { |
| bootph-pre-ram; |
| }; |
| |
| &usdhc3 { |
| bootph-pre-ram; |
| }; |
| |
| &wdog1 { |
| bootph-pre-ram; |
| }; |