phy: marvell: add SATA comphy RX/TX polarity invert support
This patch adds support to Armada 7k/8k comphy RX/TX lane swap. The
'phy-invert' DT property defines the inverted signals.
Signed-off-by: Rabeeh Khoury <rabeeh@solid-run.com>
Signed-off-by: Baruch Siach <baruch@tkos.co.il>
Signed-off-by: Stefan Roese <sr@denx.de>
diff --git a/drivers/phy/marvell/comphy_cp110.c b/drivers/phy/marvell/comphy_cp110.c
index 6a60da3..9998c07 100644
--- a/drivers/phy/marvell/comphy_cp110.c
+++ b/drivers/phy/marvell/comphy_cp110.c
@@ -641,7 +641,8 @@
}
static int comphy_sata_power_up(u32 lane, void __iomem *hpipe_base,
- void __iomem *comphy_base, int cp_index)
+ void __iomem *comphy_base, int cp_index,
+ u32 invert)
{
u32 mask, data, i, ret = 1;
void __iomem *hpipe_addr = HPIPE_ADDR(hpipe_base, lane);
@@ -927,6 +928,19 @@
reg_set(hpipe_addr + HPIPE_PWR_CTR_REG,
0x0 << HPIPE_PWR_CTR_RST_DFE_OFFSET,
HPIPE_PWR_CTR_RST_DFE_MASK);
+
+ /* Set RX / TX swaps */
+ data = mask = 0;
+ if (invert & PHY_POLARITY_TXD_INVERT) {
+ data |= (1 << HPIPE_SYNC_PATTERN_TXD_SWAP_OFFSET);
+ mask |= HPIPE_SYNC_PATTERN_TXD_SWAP_MASK;
+ }
+ if (invert & PHY_POLARITY_RXD_INVERT) {
+ data |= (1 << HPIPE_SYNC_PATTERN_RXD_SWAP_OFFSET);
+ mask |= HPIPE_SYNC_PATTERN_RXD_SWAP_MASK;
+ }
+ reg_set(hpipe_addr + HPIPE_SYNC_PATTERN_REG, data, mask);
+
/* SW reset for interupt logic */
reg_set(hpipe_addr + HPIPE_PWR_CTR_REG,
0x1 << HPIPE_PWR_CTR_SFT_RST_OFFSET,
@@ -2006,7 +2020,8 @@
case PHY_TYPE_SATA3:
ret = comphy_sata_power_up(
lane, hpipe_base_addr, comphy_base_addr,
- ptr_chip_cfg->cp_index);
+ ptr_chip_cfg->cp_index,
+ serdes_map[lane].invert);
break;
case PHY_TYPE_USB3_HOST0:
case PHY_TYPE_USB3_HOST1: