dm: treewide: Rename ofdata_to_platdata() to of_to_plat()
This name is far too long. Rename it to remove the 'data' bits. This makes
it consistent with the platdata->plat rename.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/doc/driver-model/of-plat.rst b/doc/driver-model/of-plat.rst
index b9976ac..4436c4a 100644
--- a/doc/driver-model/of-plat.rst
+++ b/doc/driver-model/of-plat.rst
@@ -174,7 +174,7 @@
struct dtd_rockchip_rk3288_dw_mshc *plat = dev_get_plat(dev);
This avoids the code overhead of converting the device tree data to
-platform data in the driver. The ofdata_to_platdata() method should
+platform data in the driver. The of_to_plat() method should
therefore do nothing in such a driver.
Note that for the platform data to be matched with a driver, the 'name'
@@ -222,7 +222,7 @@
Therefore it is recommended that the of-platdata structure should be used
only in the probe() method of your driver. It cannot be used in the
-ofdata_to_platdata() method since this is not called when platform data is
+of_to_plat() method since this is not called when platform data is
already present.
@@ -234,7 +234,7 @@
Your driver should convert the plat struct in its probe() method. The
existing device tree decoding logic should be kept in the
-ofdata_to_platdata() method and wrapped with #if.
+of_to_plat() method and wrapped with #if.
For example:
@@ -254,7 +254,7 @@
int fifo_depth;
};
- static int mmc_ofdata_to_platdata(struct udevice *dev)
+ static int mmc_of_to_plat(struct udevice *dev)
{
#if !CONFIG_IS_ENABLED(OF_PLATDATA)
/* Decode the device tree data */
@@ -291,7 +291,7 @@
.name = "mmc_drv",
.id = UCLASS_MMC,
.of_match = mmc_ids,
- .ofdata_to_platdata = mmc_ofdata_to_platdata,
+ .of_to_plat = mmc_of_to_plat,
.probe = mmc_probe,
.priv_auto = sizeof(struct mmc_priv),
.plat_auto = sizeof(struct mmc_platdata),
@@ -313,7 +313,7 @@
The of-platdata struct contents is copied from the C structure data to the
start of the newly allocated area. In the case where device tree is used,
the platform data is allocated, and starts zeroed. In this case the
-ofdata_to_platdata() method should still set up the platform data (and the
+of_to_plat() method should still set up the platform data (and the
of-platdata struct will not be present).
SPL must use either of-platdata or device tree. Drivers cannot use both at