doc: board: ti: j721e_evm: Use board relative path for include directives
When using include directives within a section that is included by non
TI board rst file, k3.rst and other include paths need to be relative to
doc/board/ base.
Signed-off-by: Nishanth Menon <nm@ti.com>
diff --git a/doc/board/ti/j721e_evm.rst b/doc/board/ti/j721e_evm.rst
index 113475d..a422a9b 100644
--- a/doc/board/ti/j721e_evm.rst
+++ b/doc/board/ti/j721e_evm.rst
@@ -48,7 +48,7 @@
Sources:
--------
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_boot_sources
:end-before: .. k3_rst_include_end_boot_sources
@@ -56,17 +56,17 @@
----------------
0. Setup the environment variables:
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_common_env_vars_desc
:end-before: .. k3_rst_include_end_common_env_vars_desc
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_board_env_vars_desc
:end-before: .. k3_rst_include_end_board_env_vars_desc
Set the variables corresponding to this platform:
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_common_env_vars_defn
:end-before: .. k3_rst_include_end_common_env_vars_defn
.. prompt:: bash $
@@ -84,14 +84,14 @@
1. Trusted Firmware-A:
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_build_steps_tfa
:end-before: .. k3_rst_include_end_build_steps_tfa
2. OP-TEE:
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_build_steps_optee
:end-before: .. k3_rst_include_end_build_steps_optee
@@ -99,13 +99,13 @@
* 3.1 R5:
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_build_steps_spl_r5
:end-before: .. k3_rst_include_end_build_steps_spl_r5
* 3.2 A72:
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_build_steps_uboot
:end-before: .. k3_rst_include_end_build_steps_uboot
.. j721e_evm_rst_include_end_build_steps
@@ -249,7 +249,7 @@
environment's distribution needs to be updated, it might be necessary to
build OpenOCD from the source.
-.. include:: k3.rst
+.. include:: ../ti/k3.rst
:start-after: .. k3_rst_include_start_openocd_connect_XDS110
:end-before: .. k3_rst_include_end_openocd_connect_XDS110