ARM: dts: stm32: Add qspi support for stm32f469-disco board
Add device tree nodes to support qspi for stm32f469-disco board.
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
diff --git a/arch/arm/dts/stm32f469-disco-u-boot.dtsi b/arch/arm/dts/stm32f469-disco-u-boot.dtsi
index a980ac4..3da308e 100644
--- a/arch/arm/dts/stm32f469-disco-u-boot.dtsi
+++ b/arch/arm/dts/stm32f469-disco-u-boot.dtsi
@@ -23,6 +23,7 @@
gpio8 = &gpioi;
gpio9 = &gpioj;
gpio10 = &gpiok;
+ spi0 = &qspi;
};
soc {
@@ -64,6 +65,19 @@
st,sdram-refcount = < 1292 >;
};
};
+
+ qspi: quadspi@A0001000 {
+ compatible = "st,stm32-qspi";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ reg = <0xA0001000 0x1000>, <0x90000000 0x10000000>;
+ reg-names = "qspi", "qspi_mm";
+ interrupts = <91>;
+ spi-max-frequency = <108000000>;
+ clocks = <&rcc 0 STM32F4_AHB3_CLOCK(QSPI)>;
+ resets = <&rcc STM32F4_AHB3_RESET(QSPI)>;
+ pinctrl-0 = <&qspi_pins>;
+ };
};
};
@@ -205,6 +219,18 @@
};
};
+ qspi_pins: qspi@0 {
+ pins {
+ pinmux = <STM32_PINMUX('F',10, AF9)>, /* CLK */
+ <STM32_PINMUX('B', 6, AF10)>, /* BK1_NCS */
+ <STM32_PINMUX('F', 8, AF10)>, /* BK1_IO0 */
+ <STM32_PINMUX('F', 9, AF10)>, /* BK1_IO1 */
+ <STM32_PINMUX('F', 7, AF9)>, /* BK1_IO2 */
+ <STM32_PINMUX('F', 6, AF9)>; /* BK1_IO3 */
+ slew-rate = <2>;
+ };
+ };
+
usart3_pins_a: usart3@0 {
u-boot,dm-pre-reloc;
pins1 {
@@ -227,3 +253,16 @@
&syscfg {
u-boot,dm-pre-reloc;
};
+
+&qspi {
+ reg = <0xA0001000 0x1000>, <0x90000000 0x1000000>;
+ flash0: n25q128a {
+ #address-cells = <1>;
+ #size-cells = <1>;
+ compatible = "jedec,spi-nor";
+ spi-max-frequency = <108000000>;
+ spi-tx-bus-width = <4>;
+ spi-rx-bus-width = <4>;
+ reg = <0>;
+ };
+};