arm: marvell: Extract kirkwood gpio functions into new common file gpio.c
This makes is possible to use those gpio functions from other MVEBU SoC's as well.
Signed-off-by: Stefan Roese <sr@denx.de>
Tested-by: Luka Perkov <luka@openwrt.org>
Acked-by: Prafulla Wadaskar <prafulla@marvell.com>
diff --git a/board/raidsonic/ib62x0/ib62x0.c b/board/raidsonic/ib62x0/ib62x0.c
index 47956b2..dbcfb43 100644
--- a/board/raidsonic/ib62x0/ib62x0.c
+++ b/board/raidsonic/ib62x0/ib62x0.c
@@ -24,9 +24,9 @@
* There are maximum 64 gpios controlled through 2 sets of registers
* the below configuration configures mainly initial LED status
*/
- kw_config_gpio(IB62x0_OE_VAL_LOW,
- IB62x0_OE_VAL_HIGH,
- IB62x0_OE_LOW, IB62x0_OE_HIGH);
+ mvebu_config_gpio(IB62x0_OE_VAL_LOW,
+ IB62x0_OE_VAL_HIGH,
+ IB62x0_OE_LOW, IB62x0_OE_HIGH);
/* Set SATA activity LEDs to default off */
writel(MVSATAHC_LED_POLARITY_CTRL, MVSATAHC_LED_CONF_REG);