| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Renesas R61307 panel driver |
| * |
| * Copyright (c) 2022 Svyatoslav Ryhel <clamor95@gmail.com> |
| */ |
| |
| #include <common.h> |
| #include <backlight.h> |
| #include <dm.h> |
| #include <panel.h> |
| #include <log.h> |
| #include <misc.h> |
| #include <mipi_display.h> |
| #include <mipi_dsi.h> |
| #include <asm/gpio.h> |
| #include <linux/delay.h> |
| #include <linux/err.h> |
| #include <power/regulator.h> |
| |
| /* |
| * The datasheet is not publicly available, all values are |
| * taken from the downstream. If you have access to datasheets, |
| * corrections are welcome. |
| */ |
| |
| #define R61307_MACP 0xB0 /* Manufacturer CMD Protect */ |
| |
| #define R61307_INVERSION 0xC1 |
| #define R61307_GAMMA_SET_A 0xC8 /* Gamma Setting A */ |
| #define R61307_GAMMA_SET_B 0xC9 /* Gamma Setting B */ |
| #define R61307_GAMMA_SET_C 0xCA /* Gamma Setting C */ |
| #define R61307_CONTRAST_SET 0xCC |
| |
| struct renesas_r61307_priv { |
| struct udevice *vcc; |
| struct udevice *iovcc; |
| |
| struct udevice *backlight; |
| |
| struct gpio_desc reset_gpio; |
| |
| bool dig_cont_adj; |
| bool inversion; |
| u32 gamma; |
| }; |
| |
| static const u8 macp_on[] = { |
| R61307_MACP, 0x03 |
| }; |
| |
| static const u8 macp_off[] = { |
| R61307_MACP, 0x04 |
| }; |
| |
| static const u8 address_mode[] = { |
| MIPI_DCS_SET_ADDRESS_MODE |
| }; |
| |
| static const u8 contrast_setting[] = { |
| R61307_CONTRAST_SET, |
| 0xdc, 0xb4, 0xff |
| }; |
| |
| static const u8 column_inversion[] = { |
| R61307_INVERSION, |
| 0x00, 0x50, 0x03, 0x22, |
| 0x16, 0x06, 0x60, 0x11 |
| }; |
| |
| static const u8 line_inversion[] = { |
| R61307_INVERSION, |
| 0x00, 0x10, 0x03, 0x22, |
| 0x16, 0x06, 0x60, 0x01 |
| }; |
| |
| static const u8 gamma_setting[][25] = { |
| {}, |
| { |
| R61307_GAMMA_SET_A, |
| 0x00, 0x06, 0x0a, 0x0f, |
| 0x14, 0x1f, 0x1f, 0x17, |
| 0x12, 0x0c, 0x09, 0x06, |
| 0x00, 0x06, 0x0a, 0x0f, |
| 0x14, 0x1f, 0x1f, 0x17, |
| 0x12, 0x0c, 0x09, 0x06 |
| }, |
| { |
| R61307_GAMMA_SET_A, |
| 0x00, 0x05, 0x0b, 0x0f, |
| 0x11, 0x1d, 0x20, 0x18, |
| 0x18, 0x09, 0x07, 0x06, |
| 0x00, 0x05, 0x0b, 0x0f, |
| 0x11, 0x1d, 0x20, 0x18, |
| 0x18, 0x09, 0x07, 0x06 |
| }, |
| { |
| R61307_GAMMA_SET_A, |
| 0x0b, 0x0d, 0x10, 0x14, |
| 0x13, 0x1d, 0x20, 0x18, |
| 0x12, 0x09, 0x07, 0x06, |
| 0x0a, 0x0c, 0x10, 0x14, |
| 0x13, 0x1d, 0x20, 0x18, |
| 0x12, 0x09, 0x07, 0x06 |
| }, |
| }; |
| |
| static struct display_timing default_timing = { |
| .pixelclock.typ = 62000000, |
| .hactive.typ = 768, |
| .hfront_porch.typ = 116, |
| .hback_porch.typ = 81, |
| .hsync_len.typ = 5, |
| .vactive.typ = 1024, |
| .vfront_porch.typ = 24, |
| .vback_porch.typ = 8, |
| .vsync_len.typ = 2, |
| }; |
| |
| static int renesas_r61307_enable_backlight(struct udevice *dev) |
| { |
| struct renesas_r61307_priv *priv = dev_get_priv(dev); |
| struct mipi_dsi_panel_plat *plat = dev_get_plat(dev); |
| struct mipi_dsi_device *dsi = plat->device; |
| int ret; |
| |
| ret = mipi_dsi_dcs_exit_sleep_mode(dsi); |
| if (ret < 0) { |
| log_err("failed to exit sleep mode: %d\n", ret); |
| return ret; |
| } |
| |
| mdelay(80); |
| |
| mipi_dsi_dcs_write_buffer(dsi, address_mode, |
| sizeof(address_mode)); |
| |
| mdelay(20); |
| |
| ret = mipi_dsi_dcs_set_pixel_format(dsi, MIPI_DCS_PIXEL_FMT_24BIT << 4); |
| if (ret < 0) { |
| log_err("failed to set pixel format: %d\n", ret); |
| return ret; |
| } |
| |
| /* MACP Off */ |
| mipi_dsi_generic_write(dsi, macp_off, sizeof(macp_off)); |
| |
| if (priv->dig_cont_adj) |
| mipi_dsi_generic_write(dsi, contrast_setting, |
| sizeof(contrast_setting)); |
| |
| if (priv->gamma) |
| mipi_dsi_generic_write(dsi, gamma_setting[priv->gamma], |
| sizeof(gamma_setting[priv->gamma])); |
| |
| if (priv->inversion) |
| mipi_dsi_generic_write(dsi, column_inversion, |
| sizeof(column_inversion)); |
| else |
| mipi_dsi_generic_write(dsi, line_inversion, |
| sizeof(line_inversion)); |
| |
| /* MACP On */ |
| mipi_dsi_generic_write(dsi, macp_on, sizeof(macp_on)); |
| |
| ret = mipi_dsi_dcs_set_display_on(dsi); |
| if (ret < 0) { |
| log_err("failed to set display on: %d\n", ret); |
| return ret; |
| } |
| mdelay(50); |
| |
| return 0; |
| } |
| |
| static int renesas_r61307_set_backlight(struct udevice *dev, int percent) |
| { |
| struct renesas_r61307_priv *priv = dev_get_priv(dev); |
| int ret; |
| |
| ret = backlight_enable(priv->backlight); |
| if (ret) |
| return ret; |
| |
| mdelay(5); |
| |
| return backlight_set_brightness(priv->backlight, percent); |
| } |
| |
| static int renesas_r61307_timings(struct udevice *dev, |
| struct display_timing *timing) |
| { |
| memcpy(timing, &default_timing, sizeof(*timing)); |
| return 0; |
| } |
| |
| static int renesas_r61307_of_to_plat(struct udevice *dev) |
| { |
| struct renesas_r61307_priv *priv = dev_get_priv(dev); |
| int ret; |
| |
| ret = uclass_get_device_by_phandle(UCLASS_PANEL_BACKLIGHT, dev, |
| "backlight", &priv->backlight); |
| if (ret) { |
| log_err("Cannot get backlight: ret = %d\n", ret); |
| return ret; |
| } |
| |
| ret = uclass_get_device_by_phandle(UCLASS_REGULATOR, dev, |
| "vcc-supply", &priv->vcc); |
| if (ret) { |
| log_err("Cannot get vcc-supply: ret = %d\n", ret); |
| return ret; |
| } |
| |
| ret = uclass_get_device_by_phandle(UCLASS_REGULATOR, dev, |
| "iovcc-supply", &priv->iovcc); |
| if (ret) { |
| log_err("Cannot get iovcc-supply: ret = %d\n", ret); |
| return ret; |
| } |
| |
| ret = gpio_request_by_name(dev, "reset-gpios", 0, |
| &priv->reset_gpio, GPIOD_IS_OUT); |
| if (ret) { |
| log_err("Could not decode reser-gpios (%d)\n", ret); |
| return ret; |
| } |
| |
| priv->dig_cont_adj = dev_read_bool(dev, "renesas,contrast"); |
| priv->inversion = dev_read_bool(dev, "renesas,inversion"); |
| priv->gamma = dev_read_u32_default(dev, "renesas,gamma", 0); |
| |
| return 0; |
| } |
| |
| static int renesas_r61307_hw_init(struct udevice *dev) |
| { |
| struct renesas_r61307_priv *priv = dev_get_priv(dev); |
| int ret; |
| |
| ret = regulator_set_enable_if_allowed(priv->vcc, 1); |
| if (ret) { |
| log_debug("%s: enabling vcc-supply failed (%d)\n", |
| __func__, ret); |
| return ret; |
| } |
| mdelay(5); |
| |
| ret = regulator_set_enable_if_allowed(priv->iovcc, 1); |
| if (ret) { |
| log_debug("%s: enabling iovcc-supply failed (%d)\n", |
| __func__, ret); |
| return ret; |
| } |
| |
| ret = dm_gpio_set_value(&priv->reset_gpio, 0); |
| if (ret) { |
| log_debug("%s: changing reset-gpio failed (%d)\n", |
| __func__, ret); |
| return ret; |
| } |
| mdelay(5); |
| |
| ret = dm_gpio_set_value(&priv->reset_gpio, 1); |
| if (ret) { |
| log_debug("%s: changing reset-gpio failed (%d)\n", |
| __func__, ret); |
| return ret; |
| } |
| |
| mdelay(5); |
| |
| return 0; |
| } |
| |
| static int renesas_r61307_probe(struct udevice *dev) |
| { |
| struct mipi_dsi_panel_plat *plat = dev_get_plat(dev); |
| |
| /* fill characteristics of DSI data link */ |
| plat->lanes = 4; |
| plat->format = MIPI_DSI_FMT_RGB888; |
| plat->mode_flags = MIPI_DSI_MODE_VIDEO; |
| |
| return renesas_r61307_hw_init(dev); |
| } |
| |
| static const struct panel_ops renesas_r61307_ops = { |
| .enable_backlight = renesas_r61307_enable_backlight, |
| .set_backlight = renesas_r61307_set_backlight, |
| .get_display_timing = renesas_r61307_timings, |
| }; |
| |
| static const struct udevice_id renesas_r61307_ids[] = { |
| { .compatible = "koe,tx13d100vm0eaa" }, |
| { .compatible = "hitachi,tx13d100vm0eaa" }, |
| { } |
| }; |
| |
| U_BOOT_DRIVER(renesas_r61307) = { |
| .name = "renesas_r61307", |
| .id = UCLASS_PANEL, |
| .of_match = renesas_r61307_ids, |
| .ops = &renesas_r61307_ops, |
| .of_to_plat = renesas_r61307_of_to_plat, |
| .probe = renesas_r61307_probe, |
| .plat_auto = sizeof(struct mipi_dsi_panel_plat), |
| .priv_auto = sizeof(struct renesas_r61307_priv), |
| }; |