regmap: Allow devices to specify regmap range start and size in config
Some devices need to calculate the regmap base address at runtime. This
makes it impossible to use device tree to get the regmap base. Instead,
allow devices to specify it in the regmap config. This will create a
regmap with a single range that corresponds to the start and size given
by the driver.
Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/drivers/core/regmap.c b/drivers/core/regmap.c
index a9087df..a3da0cf 100644
--- a/drivers/core/regmap.c
+++ b/drivers/core/regmap.c
@@ -283,7 +283,11 @@
if (unlikely(!mapp))
return ERR_PTR(-ENOMEM);
- rc = regmap_init_mem(dev_ofnode(dev), mapp);
+ if (config && config->r_size != 0)
+ rc = regmap_init_mem_range(dev_ofnode(dev), config->r_start,
+ config->r_size, mapp);
+ else
+ rc = regmap_init_mem(dev_ofnode(dev), mapp);
if (rc)
return ERR_PTR(rc);
diff --git a/include/regmap.h b/include/regmap.h
index 7c8ad04..7a6fcc7 100644
--- a/include/regmap.h
+++ b/include/regmap.h
@@ -84,10 +84,16 @@
* REGMAP_SIZE_32 if set to 0.
* @reg_offset_shift Left shift the register offset by this value before
* performing read or write.
+ * @r_start: If specified, the regmap is created with one range
+ * which starts at this address, instead of finding the
+ * start from device tree.
+ * @r_size: Same as above for the range size
*/
struct regmap_config {
enum regmap_size_t width;
u32 reg_offset_shift;
+ ulong r_start;
+ ulong r_size;
};
/**