TQM85xx: Fix a couple warnings in TQM8548 build
The ecm variable in sdram.c was being declared for all 8548, but only
used by specific 8548 boards, so we make that variable require those
specific boards, too
The nand code was using an index "i" into a table, and then re-using "i"
to set addresses for each upm. However, then it relied on the old value
of i still being there to enable things. Changed the second "i" to "j"
Signed-off-by: Andy Fleming <afleming@freescale.com>
diff --git a/board/tqc/tqm85xx/nand.c b/board/tqc/tqm85xx/nand.c
index dea652d..8133fdc 100644
--- a/board/tqc/tqm85xx/nand.c
+++ b/board/tqc/tqm85xx/nand.c
@@ -395,7 +395,7 @@
*/
static void nand_upm_setup (volatile ccsr_lbc_t *lbc)
{
- uint i;
+ uint i, j;
uint or3 = CONFIG_SYS_OR3_PRELIM;
uint clock = get_lbc_clock ();
@@ -429,8 +429,8 @@
/* Assign address of table */
nand_upm_patt = upm_freq_table[i].upm_patt;
- for (i = 0; i < 64; i++) {
- upmb_write (i, *nand_upm_patt);
+ for (j = 0; j < 64; j++) {
+ upmb_write (j, *nand_upm_patt);
nand_upm_patt++;
}
diff --git a/board/tqc/tqm85xx/sdram.c b/board/tqc/tqm85xx/sdram.c
index 2b3de44..6d73a88 100644
--- a/board/tqc/tqm85xx/sdram.c
+++ b/board/tqc/tqm85xx/sdram.c
@@ -79,7 +79,9 @@
volatile ccsr_ddr_t *ddr = (void *)(CONFIG_SYS_MPC85xx_DDR_ADDR);
#ifdef CONFIG_TQM8548
volatile ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
+#if defined(CONFIG_TQM8548_AG) || defined(CONFIG_TQM8548_BE)
volatile ccsr_local_ecm_t *ecm = (void *)(CONFIG_SYS_MPC85xx_ECM_ADDR);
+#endif
#else /* !CONFIG_TQM8548 */
unsigned long cfg_ddr_timing1;
unsigned long cfg_ddr_mode;