net: phy: don't require PHY interface mode during PHY creation
Currently we require PHY interface mode to be known when
finding/creating the PHY - the functions
* phy_connect_phy_id()
* phy_device_create()
* create_phy_by_mask()
* search_for_existing_phy()
* get_phy_device_by_mask()
* phy_find_by_mask()
all require the interface parameter, but the only thing done with it is
that it is assigned to phydev->interface.
This makes it impossible to find a PHY device without overwriting the
set mode.
Since the interface mode is not used during .probe() and should be used
at first in .config(), drop the interface parameter from these
functions. Make the default value of phydev->interface (in
phy_device_create()) to be PHY_INTERFACE_MODE_NA. Move the interface
parameter to phy_connect_dev(), where it should be.
Change all occurrences treewide. In occurrences where we don't call
phy_connect_dev() for some reason (they only configure the PHY without
connecting it to an ethernet controller), set
phydev->interface = value from phy_find_by_mask call.
Signed-off-by: Marek Behún <marek.behun@nic.cz>
Reviewed-by: Ramon Fried <rfried.dev@gmail.com>
Reviewed-by: Vladimir Oltean <vladimir.oltean@nxp.com>
diff --git a/board/gdsys/a38x/ihs_phys.c b/board/gdsys/a38x/ihs_phys.c
index e09c000..60a5c37 100644
--- a/board/gdsys/a38x/ihs_phys.c
+++ b/board/gdsys/a38x/ihs_phys.c
@@ -28,6 +28,7 @@
{
u16 reg;
+ phydev->interface = PHY_INTERFACE_MODE_MII;
phy_config(phydev);
/* enable QSGMII autonegotiation with flow control */
@@ -142,10 +143,9 @@
int init_single_phy(struct porttype *porttype, struct mii_dev *bus,
uint bus_idx, uint m, uint phy_idx)
{
- struct phy_device *phydev = phy_find_by_mask(
- bus, 1 << (m * 8 + phy_idx),
- PHY_INTERFACE_MODE_MII);
+ struct phy_device *phydev;
+ phydev = phy_find_by_mask(bus, BIT(m * 8 + phy_idx));
printf(" %u", bus_idx * 32 + m * 8 + phy_idx);
if (!phydev)