powerpc/t1024rdb: Add support for T1024RDB-PB
T1024RDB-PB board adds 2.5G SGMII support with AQR105 PHY.
rcw_0x095 is used for 10G XFI + 3x PCIex1
rcw_0x135 is used for 2.5G SGMII + 2x PCIex1
Signed-off-by: Shengzhou Liu <Shengzhou.Liu@freescale.com>
Reviewed-by: York Sun <yorksun@freescale.com>
diff --git a/board/freescale/t102xrdb/cpld.h b/board/freescale/t102xrdb/cpld.h
index 5a3100f..db50f81 100644
--- a/board/freescale/t102xrdb/cpld.h
+++ b/board/freescale/t102xrdb/cpld.h
@@ -43,3 +43,7 @@
#define CPLD_LBMAP_RESET 0xFF
#define CPLD_LBMAP_SHIFT 0x03
#define CPLD_BOOT_SEL 0x80
+
+#define CPLD_PCIE_SGMII_MUX 0x80
+#define CPLD_OVERRIDE_BOOT_EN 0x01
+#define CPLD_OVERRIDE_MUX_EN 0x02 /* PCIE/2.5G-SGMII mux override enable */
diff --git a/board/freescale/t102xrdb/eth_t102xrdb.c b/board/freescale/t102xrdb/eth_t102xrdb.c
index 2e400c4..f611ff0 100644
--- a/board/freescale/t102xrdb/eth_t102xrdb.c
+++ b/board/freescale/t102xrdb/eth_t102xrdb.c
@@ -21,6 +21,7 @@
#include <phy.h>
#include <asm/fsl_dtsec.h>
#include <asm/fsl_serdes.h>
+#include "../common/fman.h"
int board_eth_init(bd_t *bis)
{
@@ -51,15 +52,22 @@
/* Register the 10G MDIO bus */
fm_memac_mdio_init(bis, &tgec_mdio_info);
- /* Set the two on-board RGMII PHY address */
- fm_info_set_phy_address(FM1_DTSEC3, RGMII_PHY2_ADDR);
+ /* Set the on-board RGMII PHY address */
fm_info_set_phy_address(FM1_DTSEC4, RGMII_PHY1_ADDR);
switch (srds_s1) {
case 0x95:
- /* 10G XFI with Aquantia PHY */
+ /* set the on-board RGMII2 PHY */
+ fm_info_set_phy_address(FM1_DTSEC3, RGMII_PHY2_ADDR);
+
+ /* set 10G XFI with Aquantia AQR105 PHY */
fm_info_set_phy_address(FM1_10GEC1, FM1_10GEC1_PHY_ADDR);
break;
+ case 0x77:
+ case 0x135:
+ /* set the on-board 2.5G SGMII AQR105 PHY */
+ fm_info_set_phy_address(FM1_DTSEC3, SGMII_PHY1_ADDR);
+ break;
default:
printf("SerDes protocol 0x%x is not supported on T102xRDB\n",
srds_s1);
@@ -73,6 +81,10 @@
dev = miiphy_get_dev_by_name(DEFAULT_FM_MDIO_NAME);
fm_info_set_mdio(i, dev);
break;
+ case PHY_INTERFACE_MODE_SGMII_2500:
+ dev = miiphy_get_dev_by_name(DEFAULT_FM_TGEC_MDIO_NAME);
+ fm_info_set_mdio(i, dev);
+ break;
default:
break;
}
@@ -95,6 +107,18 @@
return pci_eth_init(bis);
}
+void board_ft_fman_fixup_port(void *fdt, char *compat, phys_addr_t addr,
+ enum fm_port port, int offset)
+{
+ if ((fm_info_get_enet_if(port) == PHY_INTERFACE_MODE_SGMII_2500) &&
+ (port == FM1_DTSEC3)) {
+ fdt_set_phy_handle(fdt, compat, addr, "sg_2500_aqr105_phy4");
+ fdt_setprop(fdt, offset, "phy-connection-type",
+ "sgmii-2500", 10);
+ fdt_status_disabled_by_alias(fdt, "xg_aqr105_phy3");
+ }
+}
+
void fdt_fixup_board_enet(void *fdt)
{
}
diff --git a/board/freescale/t102xrdb/t102xrdb.c b/board/freescale/t102xrdb/t102xrdb.c
index 96457cf..e196f12 100644
--- a/board/freescale/t102xrdb/t102xrdb.c
+++ b/board/freescale/t102xrdb/t102xrdb.c
@@ -27,6 +27,11 @@
{
struct cpu_type *cpu = gd->arch.cpu;
static const char *freq[3] = {"100.00MHZ", "125.00MHz", "156.25MHZ"};
+ ccsr_gur_t __iomem *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
+ u32 srds_s1;
+
+ srds_s1 = in_be32(&gur->rcwsr[4]) & FSL_CORENET2_RCWSR4_SRDS1_PRTCL;
+ srds_s1 >>= FSL_CORENET2_RCWSR4_SRDS1_PRTCL_SHIFT;
printf("Board: %sRDB, ", cpu->name);
printf("Board rev: 0x%02x CPLD ver: 0x%02x, boot from ",
@@ -50,11 +55,34 @@
#endif
puts("SERDES Reference Clocks:\n");
- printf("SD1_CLK1=%s, SD1_CLK2=%s\n", freq[2], freq[0]);
+ if (srds_s1 == 0x95)
+ printf("SD1_CLK1=%s, SD1_CLK2=%s\n", freq[2], freq[0]);
+ else
+ printf("SD1_CLK1=%s, SD1_CLK2=%s\n", freq[0], freq[0]);
return 0;
}
+static void board_mux_lane(void)
+{
+ ccsr_gur_t __iomem *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR);
+ u32 srds_prtcl_s1;
+ u8 reg = CPLD_READ(misc_ctl_status);
+
+ srds_prtcl_s1 = in_be32(&gur->rcwsr[4]) &
+ FSL_CORENET2_RCWSR4_SRDS1_PRTCL;
+ srds_prtcl_s1 >>= FSL_CORENET2_RCWSR4_SRDS1_PRTCL_SHIFT;
+
+ if (srds_prtcl_s1 == 0x95) {
+ /* Route Lane B to PCIE */
+ CPLD_WRITE(misc_ctl_status, reg & ~CPLD_PCIE_SGMII_MUX);
+ } else {
+ /* Route Lane B to SGMII */
+ CPLD_WRITE(misc_ctl_status, reg | CPLD_PCIE_SGMII_MUX);
+ }
+ CPLD_WRITE(boot_override, CPLD_OVERRIDE_MUX_EN);
+}
+
int board_early_init_f(void)
{
#if defined(CONFIG_DEEP_SLEEP)
@@ -96,6 +124,7 @@
#ifdef CONFIG_SYS_DPAA_QBMAN
setup_portals();
#endif
+ board_mux_lane();
return 0;
}
diff --git a/include/configs/T102xRDB.h b/include/configs/T102xRDB.h
index e6222f3..bd40d6a 100644
--- a/include/configs/T102xRDB.h
+++ b/include/configs/T102xRDB.h
@@ -762,8 +762,10 @@
#define CONFIG_FMAN_ENET
#define CONFIG_PHYLIB_10G
#define CONFIG_PHY_REALTEK
+#define CONFIG_PHY_AQUANTIA
#define RGMII_PHY1_ADDR 0x2
#define RGMII_PHY2_ADDR 0x6
+#define SGMII_PHY1_ADDR 0x2
#define FM1_10GEC1_PHY_ADDR 0x1
#endif