* Code cleanup, mostly for GCC-3.3.x
* Cleanup confusing use of CONFIG_ETH*ADDR - ust his only to
pre-define a MAC address; use CONFIG_HAS_ETH* to enable support for
additional ethernet addresses.
* Cleanup drivers/i82365.c - avoid duplication of code
* Fix bogus "cannot span across banks" flash error message
* Add support for CompactFlash for the CPC45 Board.
diff --git a/common/cmd_bdinfo.c b/common/cmd_bdinfo.c
index 4c5540f..ca83473 100644
--- a/common/cmd_bdinfo.c
+++ b/common/cmd_bdinfo.c
@@ -92,21 +92,21 @@
printf ("%c%02X", i ? ':' : ' ', bd->bi_enetaddr[i]);
}
-#if defined(CONFIG_ETH1ADDR)
+#if defined(CONFIG_HAS_ETH1)
puts ("\neth1addr =");
for (i=0; i<6; ++i) {
printf ("%c%02X", i ? ':' : ' ', bd->bi_enet1addr[i]);
}
#endif
-#if defined(CONFIG_ETH2ADDR)
+#if defined(CONFIG_HAS_ETH2)
puts ("\neth2addr =");
for (i=0; i<6; ++i) {
printf ("%c%02X", i ? ':' : ' ', bd->bi_enet2addr[i]);
}
#endif
-#if defined(CONFIG_ETH3ADDR)
+#if defined(CONFIG_HAS_ETH3)
puts ("\neth3addr =");
for (i=0; i<6; ++i) {
printf ("%c%02X", i ? ':' : ' ', bd->bi_enet3addr[i]);
diff --git a/common/cmd_flash.c b/common/cmd_flash.c
index 5ecf888..b2728ab 100644
--- a/common/cmd_flash.c
+++ b/common/cmd_flash.c
@@ -164,6 +164,10 @@
sect = s_last[bank];
addr_first = (sect == s_end) ? b_end + 1: info->start[sect + 1];
(*s_count) += s_last[bank] - s_first[bank] + 1;
+ } else if (addr_first >= info->start[0] && addr_first < b_end) {
+ puts ("Error: start address not on sector boundary\n");
+ rcode = 1;
+ break;
} else if (s_last[bank] >= 0) {
puts ("Error: cannot span across banks when they are"
" mapped in reverse order\n");
diff --git a/common/cmd_ide.c b/common/cmd_ide.c
index 77a0494..851ba52 100644
--- a/common/cmd_ide.c
+++ b/common/cmd_ide.c
@@ -1,5 +1,5 @@
/*
- * (C) Copyright 2000-2002
+ * (C) Copyright 2000-2004
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*
* See file CREDITS for list of people who contributed to this
@@ -144,7 +144,7 @@
/* ------------------------------------------------------------------------- */
#ifdef CONFIG_IDE_LED
-#if !defined(CONFIG_KUP4K) && !defined(CONFIG_KUP4X) &&!defined(CONFIG_BMS2003)
+#if !defined(CONFIG_KUP4K) && !defined(CONFIG_KUP4X) &&!defined(CONFIG_BMS2003) &&!defined(CONFIG_CPC45)
static void ide_led (uchar led, uchar status);
#else
extern void ide_led (uchar led, uchar status);
@@ -1548,11 +1548,12 @@
/* ------------------------------------------------------------------------- */
-#if defined(CONFIG_IDE_LED) && \
- !defined(CONFIG_AMIGAONEG3SE) && \
- !defined(CONFIG_KUP4K) && \
- !defined(CONFIG_KUP4X) && \
- !defined(CONFIG_HMI10)
+#if defined(CONFIG_IDE_LED) && \
+ !defined(CONFIG_AMIGAONEG3SE)&& \
+ !defined(CONFIG_CPC45) && \
+ !defined(CONFIG_HMI10) && \
+ !defined(CONFIG_KUP4K) && \
+ !defined(CONFIG_KUP4X)
static uchar led_buffer = 0; /* Buffer for current LED status */
@@ -1578,7 +1579,6 @@
* ATAPI Support
*/
-
#undef ATAPI_DEBUG
#ifdef ATAPI_DEBUG
@@ -1661,7 +1661,6 @@
outsw(ATA_CURR_BASE(dev)+ATA_DATA_REG, sect_buf, shorts);
}
-
static void
input_data_shorts(int dev, ushort *sect_buf, int shorts)
{
diff --git a/common/cmd_pcmcia.c b/common/cmd_pcmcia.c
index 1387e89..31f2ba2 100644
--- a/common/cmd_pcmcia.c
+++ b/common/cmd_pcmcia.c
@@ -67,6 +67,8 @@
#include <asm/arch/pxa-regs.h>
#endif
+#include <asm/io.h>
+
#if (CONFIG_COMMANDS & CFG_CMD_PCMCIA) || \
((CONFIG_COMMANDS & CFG_CMD_IDE) && defined(CONFIG_IDE_8xx_PCCARD))
@@ -540,9 +542,18 @@
ide_devices_found |= (1 << slot);
+#if CONFIG_CPC45
+#else
/* set I/O area in config reg -> only valid for ARGOSY D5!!! */
*((uchar *)(addr + config_base)) = 1;
-
+#endif
+#if 0
+ printf("\n## Config_base = %04x ###\n", config_base);
+ printf("Configuration Option Register: %02x @ %x\n", readb(addr + config_base), addr + config_base);
+ printf("Card Configuration and Status Register: %02x\n", readb(addr + config_base + 2));
+ printf("Pin Replacement Register Register: %02x\n", readb(addr + config_base + 4));
+ printf("Socket and Copy Register: %02x\n", readb(addr + config_base + 6));
+#endif
return (0);
}
#endif /* CONFIG_IDE_8xx_PCCARD */
diff --git a/common/cmd_universe.c b/common/cmd_universe.c
index 6388546..a8febff 100644
--- a/common/cmd_universe.c
+++ b/common/cmd_universe.c
@@ -28,20 +28,8 @@
#include <universe.h>
-
#if (CONFIG_COMMANDS & CFG_CMD_UNIVERSE)
-#undef DBG
-
-#ifdef DBG
-# define UNI_DBG(fmt) printf fmt
-#else
-# define UNI_DBG(fmt)
-#endif
-
-#define UNI_PRINT(fmt) printf fmt
-
-
#define PCI_VENDOR PCI_VENDOR_ID_TUNDRA
#define PCI_DEVICE PCI_DEVICE_ID_TUNDRA_CA91C042
@@ -87,18 +75,18 @@
val &= ~0xf;
dev->uregs = (UNIVERSE *)val;
- UNI_DBG(("UNIVERSE-Base : %p\n", dev->uregs));
+ debug ("UNIVERSE-Base : %p\n", dev->uregs);
/* check mapping */
- UNI_DBG((" Read via mapping, PCI_ID = %08X\n", readl(&dev->uregs->pci_id)));
+ debug (" Read via mapping, PCI_ID = %08X\n", readl(&dev->uregs->pci_id));
if (((PCI_DEVICE <<16) | PCI_VENDOR) != readl(&dev->uregs->pci_id)) {
- UNI_PRINT(("UNIVERSE: Cannot read PCI-ID via Mapping: %08x\n",
- readl(&dev->uregs->pci_id)));
+ printf ("UNIVERSE: Cannot read PCI-ID via Mapping: %08x\n",
+ readl(&dev->uregs->pci_id));
result = -1;
goto break_30;
}
- UNI_DBG(("PCI_BS = %08X\n", readl(&dev->uregs->pci_bs)));
+ debug ("PCI_BS = %08X\n", readl(&dev->uregs->pci_bs));
dev->pci_bs = readl(&dev->uregs->pci_bs);
@@ -154,12 +142,12 @@
}
if (i == 4) {
- UNI_PRINT(("universe: No Image available\n"));
+ printf ("universe: No Image available\n");
result = -1;
goto exit_10;
}
- UNI_DBG(("universe: Using image %d\n", i));
+ debug ("universe: Using image %d\n", i);
writel(pciAddr , &dev->uregs->lsi[i].bs);
writel((pciAddr + size), &dev->uregs->lsi[i].bd);
@@ -219,11 +207,11 @@
writel(ctl, &dev->uregs->lsi[i].ctl);
- UNI_DBG(("universe: window-addr=%p\n", &dev->uregs->lsi[i].ctl));
- UNI_DBG(("universe: pci slave window[%d] ctl=%08x\n", i, readl(&dev->uregs->lsi[i].ctl)));
- UNI_DBG(("universe: pci slave window[%d] bs=%08x\n", i, readl(&dev->uregs->lsi[i].bs)));
- UNI_DBG(("universe: pci slave window[%d] bd=%08x\n", i, readl(&dev->uregs->lsi[i].bd)));
- UNI_DBG(("universe: pci slave window[%d] to=%08x\n", i, readl(&dev->uregs->lsi[i].to)));
+ debug ("universe: window-addr=%p\n", &dev->uregs->lsi[i].ctl);
+ debug ("universe: pci slave window[%d] ctl=%08x\n", i, readl(&dev->uregs->lsi[i].ctl));
+ debug ("universe: pci slave window[%d] bs=%08x\n", i, readl(&dev->uregs->lsi[i].bs));
+ debug ("universe: pci slave window[%d] bd=%08x\n", i, readl(&dev->uregs->lsi[i].bd));
+ debug ("universe: pci slave window[%d] to=%08x\n", i, readl(&dev->uregs->lsi[i].to));
return 0;
@@ -251,12 +239,12 @@
}
if (i == 4) {
- UNI_PRINT(("universe: No Image available\n"));
+ printf ("universe: No Image available\n");
result = -1;
goto exit_10;
}
- UNI_DBG(("universe: Using image %d\n", i));
+ debug ("universe: Using image %d\n", i);
writel(vmeAddr , &dev->uregs->vsi[i].bs);
writel((vmeAddr + size), &dev->uregs->vsi[i].bd);
@@ -304,11 +292,11 @@
writel(ctl, &dev->uregs->vsi[i].ctl);
- UNI_DBG(("universe: window-addr=%p\n", &dev->uregs->vsi[i].ctl));
- UNI_DBG(("universe: vme slave window[%d] ctl=%08x\n", i, readl(&dev->uregs->vsi[i].ctl)));
- UNI_DBG(("universe: vme slave window[%d] bs=%08x\n", i, readl(&dev->uregs->vsi[i].bs)));
- UNI_DBG(("universe: vme slave window[%d] bd=%08x\n", i, readl(&dev->uregs->vsi[i].bd)));
- UNI_DBG(("universe: vme slave window[%d] to=%08x\n", i, readl(&dev->uregs->vsi[i].to)));
+ debug ("universe: window-addr=%p\n", &dev->uregs->vsi[i].ctl);
+ debug ("universe: vme slave window[%d] ctl=%08x\n", i, readl(&dev->uregs->vsi[i].ctl));
+ debug ("universe: vme slave window[%d] bs=%08x\n", i, readl(&dev->uregs->vsi[i].bs));
+ debug ("universe: vme slave window[%d] bd=%08x\n", i, readl(&dev->uregs->vsi[i].bd));
+ debug ("universe: vme slave window[%d] to=%08x\n", i, readl(&dev->uregs->vsi[i].to));
return 0;
diff --git a/common/environment.c b/common/environment.c
index 3d8493a..61a8d24 100644
--- a/common/environment.c
+++ b/common/environment.c
@@ -130,6 +130,9 @@
#ifdef CONFIG_ETH2ADDR
"eth2addr=" MK_STR(CONFIG_ETH2ADDR) "\0"
#endif
+#ifdef CONFIG_ETH3ADDR
+ "eth3addr=" MK_STR(CONFIG_ETH3ADDR) "\0"
+#endif
#ifdef CONFIG_ETHPRIME
"ethprime=" CONFIG_ETHPRIME "\0"
#endif