Kconfig: Add EEPROM options to Kconfig when I2C_EEPROM is set
Add the following options to drivers/misc/Kconfig:
SYS_I2C_EEPROM_ADDR
SYS_I2C_EEPROM_BUS
SYS_EEPROM_SIZE
SYS_EEPROM_PAGE_WRITE_BITS
SYS_EEPROM_PAGE_WRITE_DELAY_MS
SYS_I2C_EEPROM_ADDR_LEN
SYS_I2C_EEPROM_ADDR_OVERFLOW
This does not migrate any boards, but provides a foundations for
those who want/need these options
Signed-off-by: Adam Ford <aford173@gmail.com>
[trini: Migrate uniphier]
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig
index d1ddbbe..3d282d5 100644
--- a/drivers/misc/Kconfig
+++ b/drivers/misc/Kconfig
@@ -196,4 +196,49 @@
depends on MISC
help
Enable a generic driver for EEPROMs attached via I2C.
+
+if I2C_EEPROM
+
+config SYS_I2C_EEPROM_ADDR
+ hex "Chip address of the EEPROM device"
+ default 0
+
+config SYS_I2C_EEPROM_BUS
+ int "I2C bus of the EEPROM device."
+ default 0
+
+config SYS_EEPROM_SIZE
+ int "Size in bytes of the EEPROM device"
+ default 256
+
+config SYS_EEPROM_PAGE_WRITE_BITS
+ int "Number of bits used to address bytes in a single page"
+ default 0
+ help
+ The EEPROM page size is 2^SYS_EEPROM_PAGE_WRITE_BITS.
+ A 64 byte page, for example would require six bits.
+
+config SYS_EEPROM_PAGE_WRITE_DELAY_MS
+ int "Number of milliseconds to delay between page writes"
+ default 0
+
+config SYS_I2C_EEPROM_ADDR_LEN
+ int "Length in bytes of the EEPROM memory array address"
+ default 1
+ help
+ Note: This is NOT the chip address length!
+
+config SYS_I2C_EEPROM_ADDR_OVERFLOW
+ hex "EEPROM Address Overflow"
+ default 0
+ help
+ EEPROM chips that implement "address overflow" are ones
+ like Catalyst 24WC04/08/16 which has 9/10/11 bits of
+ address and the extra bits end up in the "chip address" bit
+ slots. This makes a 24WC08 (1Kbyte) chip look like four 256
+ byte chips.
+
+endif
+
+
endmenu