Makefile: Rename ALL-y to INPUTS-y
When binman is in use, most of the targets built by the Makefile are
inputs to binman. We then need a final rule to run binman to produce the
final outputs.
Rename the variable to indicate this, and add a new 'inputs' target.
Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Bin Meng <bmeng.cn@gmail.com>
diff --git a/scripts/Makefile.spl b/scripts/Makefile.spl
index e6d56a1..d528c99 100644
--- a/scripts/Makefile.spl
+++ b/scripts/Makefile.spl
@@ -213,42 +213,42 @@
$(call if_changed,mkimage)
endif
-ALL-y += $(obj)/$(SPL_BIN).bin
+INPUTS-y += $(obj)/$(SPL_BIN).bin
ifdef CONFIG_SAMSUNG
-ALL-y += $(obj)/$(BOARD)-spl.bin
+INPUTS-y += $(obj)/$(BOARD)-spl.bin
endif
ifneq ($(CONFIG_TARGET_SOCFPGA_GEN5)$(CONFIG_TARGET_SOCFPGA_ARRIA10),)
-ALL-y += $(obj)/$(SPL_BIN).sfp
+INPUTS-y += $(obj)/$(SPL_BIN).sfp
endif
ifdef CONFIG_ARCH_SUNXI
-ALL-y += $(obj)/sunxi-spl.bin
+INPUTS-y += $(obj)/sunxi-spl.bin
ifdef CONFIG_NAND_SUNXI
-ALL-y += $(obj)/sunxi-spl-with-ecc.bin
+INPUTS-y += $(obj)/sunxi-spl-with-ecc.bin
endif
endif
ifeq ($(CONFIG_SYS_SOC),"at91")
-ALL-y += $(obj)/boot.bin
+INPUTS-y += $(obj)/boot.bin
endif
ifdef CONFIG_TPL_BUILD
-ALL-$(CONFIG_TPL_X86_16BIT_INIT) += $(obj)/u-boot-x86-start16-tpl.bin \
+INPUTS-$(CONFIG_TPL_X86_16BIT_INIT) += $(obj)/u-boot-x86-start16-tpl.bin \
$(obj)/u-boot-x86-reset16-tpl.bin
else
-ALL-$(CONFIG_SPL_X86_16BIT_INIT) += $(obj)/u-boot-x86-start16-spl.bin \
+INPUTS-$(CONFIG_SPL_X86_16BIT_INIT) += $(obj)/u-boot-x86-start16-spl.bin \
$(obj)/u-boot-x86-reset16-spl.bin
endif
-ALL-$(CONFIG_ARCH_ZYNQ) += $(obj)/boot.bin
-ALL-$(CONFIG_ARCH_ZYNQMP) += $(obj)/boot.bin
+INPUTS-$(CONFIG_ARCH_ZYNQ) += $(obj)/boot.bin
+INPUTS-$(CONFIG_ARCH_ZYNQMP) += $(obj)/boot.bin
-ALL-$(CONFIG_ARCH_MEDIATEK) += $(obj)/u-boot-spl-mtk.bin
+INPUTS-$(CONFIG_ARCH_MEDIATEK) += $(obj)/u-boot-spl-mtk.bin
-all: $(ALL-y)
+all: $(INPUTS-y)
quiet_cmd_cat = CAT $@
cmd_cat = cat $(filter-out $(PHONY), $^) > $@