net: ravb: Detect PHY correctly
The order of parameters passed to the phy_connect() was wrong.
Moreover, only PHY address 0 was used. Replace this with code
capable of detecting the PHY address.
Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c
index 7f0e256..ce0eacc 100644
--- a/drivers/net/ravb.c
+++ b/drivers/net/ravb.c
@@ -298,13 +298,14 @@
struct ravb_priv *eth = dev_get_priv(dev);
struct eth_pdata *pdata = dev_get_platdata(dev);
struct phy_device *phydev;
- int reg;
+ int mask = 0xffffffff, reg;
- phydev = phy_connect(eth->bus, pdata->phy_interface,
- dev, PHY_INTERFACE_MODE_RGMII_ID);
+ phydev = phy_find_by_mask(eth->bus, mask, pdata->phy_interface);
if (!phydev)
return -ENODEV;
+ phy_connect_dev(phydev, dev);
+
eth->phydev = phydev;
/* 10BASE is not supported for Ethernet AVB MAC */