usb: ehci: add Faraday USB 2.0 EHCI support
This patch adds support to both Faraday FUSBH200 and FOTG210,
the differences between Faraday EHCI and standard EHCI are
listed bellow:
1. The PORTSC starts at 0x30 instead of 0x44.
2. The CONFIGFLAG(0x40) is not only un-implemented, and
also has its address space removed.
3. Faraday EHCI is a TDI design, but it doesn't
compatible with the general TDI implementation
found at both U-Boot and Linux.
4. The ISOC descriptors differ from standard EHCI in
several ways. But since U-boot doesn't support ISOC,
we don't have to worry about that.
Signed-off-by: Kuo-Jung Su <dantesu@faraday-tech.com>
CC: Marek Vasut <marex@denx.de>
diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c
index 7e8e85c..28b6007 100644
--- a/drivers/usb/host/ehci-hcd.c
+++ b/drivers/usb/host/ehci-hcd.c
@@ -589,10 +589,12 @@
dev->act_len = length - QT_TOKEN_GET_TOTALBYTES(token);
} else {
dev->act_len = 0;
+#ifndef CONFIG_USB_EHCI_FARADAY
debug("dev=%u, usbsts=%#x, p[1]=%#x, p[2]=%#x\n",
dev->devnum, ehci_readl(&ctrl->hcor->or_usbsts),
ehci_readl(&ctrl->hcor->or_portsc[0]),
ehci_readl(&ctrl->hcor->or_portsc[1]));
+#endif
}
free(qtd);
@@ -980,10 +982,13 @@
cmd |= CMD_RUN;
ehci_writel(&ehcic[index].hcor->or_usbcmd, cmd);
+#ifndef CONFIG_USB_EHCI_FARADAY
/* take control over the ports */
cmd = ehci_readl(&ehcic[index].hcor->or_configflag);
cmd |= FLAG_CF;
ehci_writel(&ehcic[index].hcor->or_configflag, cmd);
+#endif
+
/* unblock posted write */
cmd = ehci_readl(&ehcic[index].hcor->or_usbcmd);
mdelay(5);