cm_t335: add support for status LED
Add support for status LED. Use the STATUS_LED APIs for indicating a
boot progress.
Signed-off-by: Ilya Ledvich <ilya@compulab.co.il>
Signed-off-by: Igor Grinberg <grinberg@compulab.co.il>
diff --git a/board/compulab/cm_t335/cm_t335.c b/board/compulab/cm_t335/cm_t335.c
index a318962..01019e8 100644
--- a/board/compulab/cm_t335/cm_t335.c
+++ b/board/compulab/cm_t335/cm_t335.c
@@ -31,6 +31,9 @@
gpmc_init();
+#if defined(CONFIG_STATUS_LED) && defined(STATUS_LED_BOOT)
+ status_led_set(STATUS_LED_BOOT, STATUS_LED_OFF);
+#endif
return 0;
}
diff --git a/board/compulab/cm_t335/mux.c b/board/compulab/cm_t335/mux.c
index 998d304..7d2beb0 100644
--- a/board/compulab/cm_t335/mux.c
+++ b/board/compulab/cm_t335/mux.c
@@ -94,6 +94,11 @@
{-1},
};
+static struct module_pin_mux status_led_pin_mux[] = {
+ {OFFSET(gpmc_csn3), (MODE(7) | PULLUDEN)}, /* GPIO2_0 */
+ {-1},
+};
+
void set_uart_mux_conf(void)
{
configure_module_pin_mux(uart0_pin_mux);
@@ -108,4 +113,5 @@
configure_module_pin_mux(eth_phy_rst_pin_mux);
configure_module_pin_mux(mmc0_pin_mux);
configure_module_pin_mux(nand_pin_mux);
+ configure_module_pin_mux(status_led_pin_mux);
}