eth: mtk-eth: fix incorrect read of phy-handle
In mt7629-rfb.dts, the phy-handle is a reference to the node phy0, not the
node itself:
phy-handle = <&phy0>;
phy0: ethernet-phy@0 {
reg = <0>;
}
However the driver used ofnode_find_subnode("phy-handle") to read the node.
It will always fail.
This patch replaces ofnode_find_subnode with dev_read_phandle_with_args to
make sure the node can be read correctly.
Cc: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Weijie Gao <weijie.gao@mediatek.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
diff --git a/drivers/net/mtk_eth.c b/drivers/net/mtk_eth.c
index cc09404..0ef814c 100644
--- a/drivers/net/mtk_eth.c
+++ b/drivers/net/mtk_eth.c
@@ -1130,13 +1130,14 @@
&priv->rst_gpio, GPIOD_IS_OUT);
}
} else {
- subnode = ofnode_find_subnode(dev_ofnode(dev), "phy-handle");
- if (!ofnode_valid(subnode)) {
+ ret = dev_read_phandle_with_args(dev, "phy-handle", NULL, 0,
+ 0, &args);
+ if (ret) {
printf("error: phy-handle is not specified\n");
return ret;
}
- priv->phy_addr = ofnode_read_s32_default(subnode, "reg", -1);
+ priv->phy_addr = ofnode_read_s32_default(args.node, "reg", -1);
if (priv->phy_addr < 0) {
printf("error: phy address is not specified\n");
return ret;