siemens: etamin: Enable DM_SPI, DM_SPI_FLASH
Enable DM_SPI, DM_SPI_FLASH for siemens etamin board.
Build is fine, but not tested.
Cc: Samuel Egli <samuel.egli@siemens.com>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
diff --git a/configs/etamin_defconfig b/configs/etamin_defconfig
index ee31e26..583331d 100644
--- a/configs/etamin_defconfig
+++ b/configs/etamin_defconfig
@@ -8,6 +8,7 @@
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0x980000
CONFIG_SYS_SPI_U_BOOT_OFFS=0x20000
+CONFIG_SPL_DM_SPI=y
CONFIG_AM33XX=y
CONFIG_SYS_MPUCLK=300
CONFIG_TARGET_ETAMIN=y
@@ -28,6 +29,7 @@
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_ARCH_MISC_INIT=y
CONFIG_SPL_I2C_SUPPORT=y
+CONFIG_SPL_DM_SPI_FLASH=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SPL_WATCHDOG_SUPPORT=y
CONFIG_SPL_YMODEM_SUPPORT=y
@@ -44,7 +46,6 @@
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_NAND=y
-CONFIG_CMD_SF=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DHCP=y
@@ -60,24 +61,27 @@
CONFIG_CMD_UBI=y
# CONFIG_DOS_PARTITION is not set
CONFIG_OF_CONTROL=y
+CONFIG_SPL_OF_CONTROL=y
CONFIG_OF_EMBED=y
CONFIG_DEFAULT_DEVICE_TREE="am335x-draco"
CONFIG_ENV_IS_IN_NAND=y
CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+CONFIG_SPL_DM=y
CONFIG_BOOTCOUNT_LIMIT=y
CONFIG_BOOTCOUNT_ENV=y
CONFIG_DFU_NAND=y
CONFIG_MMC_OMAP_HS=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
-CONFIG_SPI_FLASH=y
+CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_WINBOND=y
CONFIG_MTD_UBI_FASTMAP=y
CONFIG_MTD_UBI_FASTMAP_AUTOCONVERT=1
CONFIG_PHY_SMSC=y
CONFIG_DRIVER_TI_CPSW=y
CONFIG_SPI=y
+CONFIG_DM_SPI=y
CONFIG_OMAP3_SPI=y
CONFIG_USB=y
CONFIG_USB_MUSB_HOST=y