spl: Add Kconfig options for NVME
Add kconfig options to enable NVME and PCI NVMe support in SPL
Signed-off-by: Mayuresh Chitale <mchitale@ventanamicro.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 6774ba5..ae0d507 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -1263,6 +1263,32 @@
Sector on the SATA disk to load U-Boot from, when the SATA disk is being
used in raw mode. Units: SATA disk sectors (1 sector = 512 bytes).
+config SPL_NVME
+ bool "NVM Express device support"
+ depends on BLK
+ select HAVE_BLOCK_DEVICE
+ select FS_LOADER
+ help
+ This option enables support for NVM Express devices.
+ It supports basic functions of NVMe (read/write).
+
+config SPL_NVME_PCI
+ bool "NVM Express PCI device support for SPL"
+ depends on SPL_PCI && SPL_NVME
+ help
+ This option enables support for NVM Express PCI devices.
+ This allows use of NVMe devices for loading u-boot.
+
+config SPL_NVME_BOOT_DEVICE
+ hex "NVMe boot device number"
+ depends on SPL_NVME
+ default 0x0
+
+config SYS_NVME_BOOT_PARTITION
+ hex "NVMe boot partition number"
+ depends on SPL_NVME
+ default 0x1
+
config SPL_SERIAL
bool "Support serial"
select SPL_PRINTF