ARM: HYP/non-sec: allow relocation to secure RAM
The current non-sec switching code suffers from one major issue:
it cannot run in secure RAM, as a large part of u-boot still needs
to be run while we're switched to non-secure.
This patch reworks the whole HYP/non-secure strategy by:
- making sure the secure code is the *last* thing u-boot executes
before entering the payload
- performing an exception return from secure mode directly into
the payload
- allowing the code to be dynamically relocated to secure RAM
before switching to non-secure.
This involves quite a bit of horrible code, specially as u-boot
relocation is quite primitive.
Signed-off-by: Marc Zyngier <marc.zyngier@arm.com>
Acked-by: Ian Campbell <ijc@hellion.org.uk>
diff --git a/arch/arm/include/asm/armv7.h b/arch/arm/include/asm/armv7.h
index 395444e..11476dd 100644
--- a/arch/arm/include/asm/armv7.h
+++ b/arch/arm/include/asm/armv7.h
@@ -78,13 +78,17 @@
#if defined(CONFIG_ARMV7_NONSEC) || defined(CONFIG_ARMV7_VIRT)
-int armv7_switch_nonsec(void);
-int armv7_switch_hyp(void);
+int armv7_init_nonsec(void);
/* defined in assembly file */
unsigned int _nonsec_init(void);
+void _do_nonsec_entry(void *target_pc, unsigned long r0,
+ unsigned long r1, unsigned long r2);
void _smp_pen(void);
-void _switch_to_hyp(void);
+
+extern char __secure_start[];
+extern char __secure_end[];
+
#endif /* CONFIG_ARMV7_NONSEC || CONFIG_ARMV7_VIRT */
#endif /* ! __ASSEMBLY__ */