armv8: ls1043ardb: Use static DDR setting for SPL boot
This board has soldered DDR chips. To reduce the SPL image size,
use static DDR setting instead of dynamic DDR driver.
Signed-off-by: York Sun <york.sun@nxp.com>
diff --git a/include/configs/ls1043ardb.h b/include/configs/ls1043ardb.h
index ca1d862..da87497 100644
--- a/include/configs/ls1043ardb.h
+++ b/include/configs/ls1043ardb.h
@@ -28,13 +28,13 @@
#define CONFIG_SYS_SPD_BUS_NUM 0
-#define CONFIG_FSL_DDR_BIST
#ifndef CONFIG_SPL
-#define CONFIG_FSL_DDR_INTERACTIVE /* Interactive debugging */
-#endif
#define CONFIG_SYS_DDR_RAW_TIMING
+#define CONFIG_FSL_DDR_INTERACTIVE /* Interactive debugging */
+#define CONFIG_FSL_DDR_BIST
#define CONFIG_ECC_INIT_VIA_DDRCONTROLLER
#define CONFIG_MEM_INIT_VALUE 0xdeadbeef
+#endif
#ifdef CONFIG_RAMBOOT_PBL
#define CONFIG_SYS_FSL_PBL_PBI board/freescale/ls1043ardb/ls1043ardb_pbi.cfg