arm: mach-k3: am6_init: Use CONFIG_TI_I2C_BOARD_DETECT
We only want to call do_board_detect() if CONFIG_TI_I2C_BOARD_DETECT
is set. Same as done for am64.
This makes it possible to add a custom am65 based board design to
U-Boot that does not use this board detection mechanism.
Signed-off-by: Christian Gmeiner <christian.gmeiner@gmail.com>
diff --git a/board/ti/am65x/evm.c b/board/ti/am65x/evm.c
index fbe33cb..7182a8c 100644
--- a/board/ti/am65x/evm.c
+++ b/board/ti/am65x/evm.c
@@ -129,6 +129,7 @@
}
#endif
+#ifdef CONFIG_TI_I2C_BOARD_DETECT
int do_board_detect(void)
{
int ret;
@@ -353,23 +354,26 @@
return 0;
}
+#endif
int board_late_init(void)
{
- struct ti_am6_eeprom *ep = TI_AM6_EEPROM_DATA;
+ if (IS_ENABLED(CONFIG_TI_I2C_BOARD_DETECT)) {
+ struct ti_am6_eeprom *ep = TI_AM6_EEPROM_DATA;
- setup_board_eeprom_env();
+ setup_board_eeprom_env();
- /*
- * The first MAC address for ethernet a.k.a. ethernet0 comes from
- * efuse populated via the am654 gigabit eth switch subsystem driver.
- * All the other ones are populated via EEPROM, hence continue with
- * an index of 1.
- */
- board_ti_am6_set_ethaddr(1, ep->mac_addr_cnt);
+ /*
+ * The first MAC address for ethernet a.k.a. ethernet0 comes from
+ * efuse populated via the am654 gigabit eth switch subsystem driver.
+ * All the other ones are populated via EEPROM, hence continue with
+ * an index of 1.
+ */
+ board_ti_am6_set_ethaddr(1, ep->mac_addr_cnt);
- /* Check for and probe any plugged-in daughtercards */
- probe_daughtercards();
+ /* Check for and probe any plugged-in daughtercards */
+ probe_daughtercards();
+ }
return 0;
}