configs: Re-sync with CONFIG_DISTRO_DEFAULTS
A number of platforms include config_distro_defaults.h but do not enable
CONFIG_DISTRO_DEFAULTS. As they plainly intended to, set that flag and
re-sync config files.
Signed-off-by: Tom Rini <trini@konsulko.com>
diff --git a/configs/cm_t54_defconfig b/configs/cm_t54_defconfig
index ca80f18..07a52f6 100644
--- a/configs/cm_t54_defconfig
+++ b/configs/cm_t54_defconfig
@@ -4,16 +4,16 @@
CONFIG_TARGET_CM_T54=y
CONFIG_OMAP_PLATFORM_RESET_TIME_MAX_USEC=16296
# CONFIG_SPL_NAND_SUPPORT is not set
+CONFIG_DISTRO_DEFAULTS=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_BOOTDELAY=3
+# CONFIG_USE_BOOTCOMMAND is not set
CONFIG_SYS_CONSOLE_INFO_QUIET=y
CONFIG_VERSION_VARIABLE=y
CONFIG_SPL=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x200
CONFIG_SPL_SATA_SUPPORT=y
-CONFIG_HUSH_PARSER=y
CONFIG_SYS_PROMPT="CM-T54 # "
-CONFIG_CMD_BOOTZ=y
CONFIG_CMD_ASKENV=y
CONFIG_CMD_EEPROM=y
CONFIG_CMD_EEPROM_LAYOUT=y
@@ -22,21 +22,11 @@
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
-CONFIG_CMD_PART=y
CONFIG_CMD_SPI=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
-CONFIG_CMD_DHCP=y
# CONFIG_CMD_NFS is not set
-CONFIG_CMD_MII=y
-CONFIG_CMD_PING=y
-CONFIG_CMD_EXT2=y
-CONFIG_CMD_EXT4=y
CONFIG_CMD_EXT4_WRITE=y
-CONFIG_CMD_FAT=y
-CONFIG_CMD_FS_GENERIC=y
-CONFIG_ISO_PARTITION=y
-CONFIG_EFI_PARTITION=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_SCSI_AHCI=y
CONFIG_MMC_OMAP_HS=y