| if TARGET_SL28 |
| |
| config SYS_BOARD |
| default "sl28" |
| |
| config SYS_VENDOR |
| default "kontron" |
| |
| config SYS_SOC |
| default "fsl-layerscape" |
| |
| config SYS_CONFIG_NAME |
| default "kontron_sl28" |
| |
| config TEXT_BASE |
| default 0x96000000 |
| |
| config SL28_SPL_LOADS_ATF_BL31 |
| bool "SPL loads BL31 of the ARM Trusted Firmware" |
| select SPL_ATF |
| select SPL_ATF_LOAD_IMAGE_V2 |
| select ARMV8_SEC_FIRMWARE_SUPPORT |
| select SEC_FIRMWARE_ARMV8_PSCI |
| help |
| Enable this to load a BL31 image by the SPL. You have to |
| provde a bl31.bin in u-boot's root directory. |
| |
| if SL28_SPL_LOADS_ATF_BL31 |
| |
| config SL28_BL31_ENTRY_ADDR |
| hex "Entry point of the BL31 image" |
| default 0xfbe00000 |
| |
| endif |
| |
| config SL28_SPL_LOADS_OPTEE_BL32 |
| bool "SPL loads OP-TEE Trusted OS as BL32" |
| depends on SL28_SPL_LOADS_ATF_BL31 |
| help |
| Enable this to load a BL32 image by the SPL. You have to |
| provde a tee.bin in u-boot's root directory. |
| |
| if SL28_SPL_LOADS_OPTEE_BL32 |
| |
| config SL28_BL32_ENTRY_ADDR |
| hex "Entry point of the BL32 image" |
| default 0xfc000000 |
| |
| endif |
| |
| config SL28_ENABLE_SER0_CONSOLE |
| bool "Enable console output on SER0" |
| select DM_SERIAL |
| select SPL_DM_SERIAL |
| select FSL_LPUART |
| help |
| By default the console output of this board is on the second serial |
| line (SER1). Sometimes it is desirable to enable output on the first |
| serial line (SER0). For example, if you have a carrier which only |
| supports the first serial port. |
| endif |