bootcount: clarify documentation

- Grammar fixes
- Clarify explanations

Signed-off-by: Michael Opdenacker <michael.opdenacker@bootlin.com>
Reviewed-by: Heiko Schocher <hs@denx.de>
diff --git a/doc/README.bootcount b/doc/README.bootcount
index b1c2290..f6c5f82 100644
--- a/doc/README.bootcount
+++ b/doc/README.bootcount
@@ -3,14 +3,16 @@
 Boot Count Limit
 ================
 
+This is enabled by CONFIG_BOOTCOUNT_LIMIT.
+
 This allows to detect multiple failed attempts to boot Linux.
 
-After a power-on reset, "bootcount" variable will be initialized with 1, and
+After a power-on reset, the "bootcount" variable will be initialized to 1, and
 each reboot will increment the value by 1.
 
 If, after a reboot, the new value of "bootcount" exceeds the value of
 "bootlimit", then instead of the standard boot action (executing the contents of
-"bootcmd") an alternate boot action will be performed, and the contents of
+"bootcmd"), an alternate boot action will be performed, and the contents of
 "altbootcmd" will be executed.
 
 If the variable "bootlimit" is not defined in the environment, the Boot Count
@@ -18,18 +20,18 @@
 then U-Boot will drop into interactive mode and remain there.
 
 It is the responsibility of some application code (typically a Linux
-application) to reset the variable "bootcount", thus allowing for more boot
-cycles.
+application) to reset the variable "bootcount" to 0 when the system booted
+successfully, thus allowing for more boot cycles.
 
-BOOTCOUNT_EXT
--------------
+CONFIG_BOOTCOUNT_EXT
+--------------------
 
 This adds support for maintaining boot count in a file on an EXT filesystem.
-The file to use is define by:
+The file to use is defined by:
 
-SYS_BOOTCOUNT_EXT_INTERFACE
-SYS_BOOTCOUNT_EXT_DEVPART
-SYS_BOOTCOUNT_EXT_NAME
+CONFIG_SYS_BOOTCOUNT_EXT_INTERFACE
+CONFIG_SYS_BOOTCOUNT_EXT_DEVPART
+CONFIG_SYS_BOOTCOUNT_EXT_NAME
 
 The format of the file is:
 
@@ -42,10 +44,10 @@
 u8   upgrade_available
 ==== =================
 
-To prevent unattended usage of "altbootcmd" the "upgrade_available" variable is
+To prevent unattended usage of "altbootcmd", the "upgrade_available" variable is
 used.
-If "upgrade_available" is 0, "bootcount" is not saved, if "upgrade_available" is
-1 "bootcount" is save.
-So the Userspace Application must set the "upgrade_available" and "bootcount"
-variables to 0, if a boot was successfully.
-This also prevents writes on all reboots.
+If "upgrade_available" is 0, "bootcount" is not saved.
+If "upgrade_available" is 1, "bootcount" is saved.
+So a userspace application should take care of setting the "upgrade_available"
+and "bootcount" variables to 0, if the system boots successfully.
+This also avoids writing the "bootcount" information on all reboots.